Multitech MTE-LAT6-B07 User manual

Current manufacturer information: Multitech model MTE-LAT6-B07
The Multitech cellular modem is a cellular to Ethernet modem that can provide the eGauge unit
with internet access on a 4G LTE T-Mobile or AT&T network.
Multitech Cell Modem
Cellular: T-Mobile LTE Cat. 4
Operating Temperature range: -10°C to +50°C
Relative humidity: 10% to 85% operating / 5% to 90% storage
Cellular Modem (Multitech
MTE-LAT6-B07)
Visit the online store page
A compatible T-Mobile dataplan can be purchased through eGauge Systems. eGauge cannot
guarantee support for dataplans from other parties.
Metered (not unlimited) data plans can accrue charges for data overages. eGauge
recommends against using metered data plans without extensive testing for data usage.
Data usage is not fully predictable and will greatly vary with interface access. Seethis
article for additional information on data usage.
Specifications
Full specs (data-sheet PDF)

Multitech cellular modem kit
1x Multitech cellular modem
2x Antenna
1x 120V Power Adapter
1x Ethernet cable
4x Rubber feet stickers
1x DIN rail mounting stick
Cellular router accessory Kit
2x Rubber O-Ring
2x Extension Cable (short, SMA)
1x DIN rail mounting clips (black)
Ensure both antennas are connected to the modem
Do not install the antennas inside a metal enclosure, underground, or anywhere the
signal may be blocked or degraded
If a dataplan is purchased at the same time as the Multitech cellular modem, the modem will come
with the SIM card installed and pre-activated on the T-Mobile network.
1. If using a non-eGauge data plan, insert the SIM card to the cellular modem according to
the Multitech quick start guide that comes with the modem.
2. If applicable, attach the DIN rail mounting stick and DIN rail clips to the Multitech cellular
modem and mount in the enclosure.
3. Connect the 2 SMA antenna extension cables to the Multitech antenna ports, and into pre-
drilled holes on the enclosure. Use the 2 rubber O-rings to make a watertight seal.
4. Attach the 2 antennas to the extension cables.
5. Connect the Ethernet cable from the eGauge to the Multitech cell modem.
Hardware included
Assembly/installation information
Example setup for installing inside
enclosure

6. Plug the power supply into a 120V outlet and the barrel jack to the Multitech modem.
When purchased with a dataplan, eGauge Systems pre-configures and tests the modems with the
T-Mobile data plan purchased.
Multitech Cell Modem Configuration and troubleshooting(MTE-LAT6-B07, and MTE-LAT2-B07
models)
Multitech MTE-LAT6-B07 Spec sheet
Multitech MTE-LAT6-B07 User Guide
Multitech MTE-LAT6-B07 Quick Start Guide
How much data does the eGauge use?
Multitech MTR-H5 cellular modem configuration (legacy)
Maestro E206XT cellular modem configuration (legacy)
Software configuration Information
Documents
Related Information
Revision #9
Created Fri, Jan 31, 2020 10:20 PM by Andrew
Updated Tue, Jun 23, 2020 2:16 AM by aaron