Multitek MB-45 Dimensions and installation guide

MB-45 VISUAL APARTMENT MONITOR
USER MANUAL AND WARRANTY CERTIFICATE
MB-45
AEEE complies with the regulation.

2
MB-45 VISUAL APARTMENT MONITOR
USER MANUAL
Thank you for choosing Multitek MB-45 VIDEO APARTMENT
MONITOR. This user manual has been prepared to teach you the
features of your device and to use it more efficiently.
YOUR MULTITEK MB-45 DEVICE IS GUARANTEED FOR 2 YEARS
AGAINST MANUFACTURING DEFECTS.
THE LIFE OF THIS DEVICE IS 5 YEARS.

3
CONTENTS:
SAFETY WARNINGS 4
1. FEATURES 5
2. APPEARANCE 5
3. IMAGE AND RING SETTINGS 5
3.1 Image settings 6
3.2 Ringtone settings 7
4. MB-45 INTERCOM SYSTEM CONNECTION 7
5. USING THE DEVICE 8
5.1 Answering outside door or other incoming calls 8
5.2 Apartment door (interior bell) incoming calls 8
5.3 Getting the image of the outer door 8
5.4 Searching for the outer door 8
5.5 Call the concierge 8
5.6 Searching for security 8
5.7 Connecting to doors in multi-door apartments 8
5.8 Getting the external camera image 8
6. ROOM KEYS CODING 8
7. TROUBLESHOOTING 9
ELECTIONAL RIGHTS OF THE CONSUMER 10
AUTHORIZED SERVICE STATIONS 10
WARRANTY CERTIFICATE 11
WARRANTY CONDITIONS 12

4
SAFETY WARNINGS:
For your device and your safety, some safety rules must be followed.
•Read the user manual carefully.
•Read the safety warnings carefully.
Matters to be considered during handling, transportation and storage;
•During transportation and transportation, always carry the product with its box. The box of
the product will protect the product from physical damage.
•Do not place heavy objects on the device or its box. The device may be damaged.
•If the device is dropped, the device may not work or permanent damage may occur.
•Too cold or hot may cause deformation in the product. May shorten the life of electronic
circuits or cause them to fail.
Situations that may be dangerous or harmful to human or environmental health during use;
•Pay attention to the sharp edges when taking the product out of the box. Dispose of the
product packaging in waste bins separated by type.
Device Maintenance;
•Your device does not require periodic maintenance and only apply to authorized services for
maintenance and repair.
•You can clean the product periodically by wiping it with a dry cloth. Unplug the device before
cleaning. Cleaning agents such as alcohol, gasoline, thinner, etc. make sure it does not contain
any solvents. Wipe the device with a dry cloth.
•Do not use cables other than the original cable in order to prevent a possible electric shock.
•Do not insert foreign objects into your device or try to open it with tools that may cause
electric shock.
•Connection and installation of your device by anyone other than the authorized service may
cause damage to the device.
Considerations regarding the energy consumption of the device;
The device is designed to operate continuously 24/7. However, in case the device will not be used for
a long time, it is recommended to remove the device from the socket connection at the back so that
the device does not consume unnecessary energy. In addition, it should not be forgotten that every
terminal that is left open consumes unnecessary energy and care should be taken to keep the
terminals closed.

5
1. FEATURES:
• Color LCD 4.3” (420xRGBx272 pixel) screen
• Dimensions: 184 X 110 X 21.5 mm (With mounting bracket)
• Connecting to the door, Looking for a concierge, Security search, Door release
buttons
• Exterior door –Interior door - Security separate ringtones
• 5 different ringtone options
• Opening the image with the monitor button
• Ringtone/color/brightness adjustment with 4 buttons
• Operating voltage 18Vdc
2. APPEARANCE:
Microphone
Connecting to Door / Talking
Speaker
Searching for
Security
Screen
Screen On/Off
Calling the
Doorman
Opening the
Door

6
3. IMAGE AND RING TONE SETTINGS:
3.1 Image settings:
1. Step
Press the following buttons respectively for the setting screen.
1 2 3
2. Step
Press the SECURITY button to switch between settings.
Brightness adjustment:
When the settings screen is open, the top brightness setting is
selected as YELLOW .
By pressing the basket button, the brightness setting is changed.
Color setting:
When the settings screen is open, the color setting in
the middle is selected as YELLOW .
The color setting is changed by pressing the basket button.
Ringtone setting:
When the settings screen is open, the bottom ringtone setting
is selected as YELLOW .
The ringtone setting is changed by pressing the basket button.

7
3.2 Ringtone settings:
1. Step
Press the buttons below in order.
1 2 3
2. Step
Press the relevant button for the bell point you want to select.
Exterior Door Room Door Doorman Security
3. Step
Select the melody you want with the KEY button.
4. Step
Save your preferred melody with the BASKET button.
4. MB-45 INTERCOM SYSTEM CONNECTION:
Note: A 75 Ohm terminating resistor is used to terminate the line. If necessary, use the 75 Ohm
termination jumper to terminate the intercom connection line .

8
5. USING THE DEVICE:
Answering outside door or other incoming calls
Incoming calls from the outside door, your apartment monitor will ring and the screen
will display. ( ) you press the button. Talking ( ) you press the button. Release the
button while listening. “Push to talk & Leave to listen”
Talk time is 1 minute. Key ( ) If you press the button, the door will open.
5.1 Incoming calls at the apartment door
Your apartment monitor will ring when the apartment door bell
button is pressed. It means there's someone at the door.
5.2 Getting the image of the outer door
Monitor ( ) press button. The screen turns off automatically after about a minute.
5.3 Searching for the outer door
Exterior Door( ) press button. You will be video-connected to the door.
5.4 Call the concierge
Doorman ( ) press button. The other party's bell rings. Conversation begins
when the answer is given.
5.5 Searching for security
Securiyt ( ) press button. The other party's bell rings. Conversation begins when
the answer is given.
5.6 For those who go in multi-door apartments
Exterior Door ( ) Press the button repeatedly (1 second intervals). For example,
if you press and release twice, you will be connected to the 2nd door.
5.7 Getting the external camera image
( ) Press the button repeatedly (1 second intervals). For example, if
you press and release it twice, you will see the external camera
image on the monitor.
6. CODING OF ROOM KEYS:
Apartment keys need to be coded according to the apartment number. At the door
and other calls, the doorbell rings according to the code set from the apartment key.
Sample; If the flat number is 1, switch 1 opens, other
switches remain closed.

9
7. TROUBLESHOOTING:
NO OR LOW TALK SOUND
Check Speaker Volume Adjustment. (See. Page 6)
IF THE APARTMENT MONITOR AUDIO IS NOISE
Check the apartment monitor intercom line connections.
NO RING OR LOW
Check the Ring Volume Adjustment. (See. Page 5)
IMAGE PROBLEM
You can adjust the appropriate image color with the Color, Brightness level
adjustment.
TARİH: 19.07.2019 REVİZYON TARİHİ: 22.10.2020 REVİZYON NO:02 DOKÜMAN NO: MLŞ14-72 SAYFA NO: 12/12