NENKO 18517112 User manual

1. Name of product
Nenko Interactive - Light Source for fibre optics
2. Product code
18517112
3. Colour
White
4. Short description
LED Light source for Super safe fibre optics. Equipped with ON / OFF and PAUSE button for a fixed
colour, switch and USB connection for service purposes. Add a switch from the Nenko Interactive
program and wirelessly control the colours of the fiber mist or of all linked Nenko Interactive
products in the room. Connection 3 cm diameter.
5. Content
1 x Nenko Interactive Light Source
1 x Power adapter with American, European and Australian adapters
6. Sensory stimulations
See
7. Safety
•Suitable for indoor use in dry areas.
•Do not try to open the light source, it contains sensitive electronics.
•Make sure the light source is mounted in a place with good ventilation and not under
cushions or something. The unit will get warm and needs ventilation.
•Do not attach anything other than a fiber mist bundle into the circular recess of the light
source.
•Only use the power adapter supplied with the product.
8. Technical information
Power adapter:
•Input voltage (power adapter) 100-240Vac 50/60HZ
•Input voltage (power adapter)
•Output voltage (power adapter) 12V 1.25A (15Watt)
•Approval: CE, UL, CUL
Light source:
•Input voltage 12V
•LED output power 9W
•Approval: CE –ROHS

9. Installation
Step 1:
Carefully remove the packaging from the light source.
Step 2:
1. Attach the metal round end part of the fiber mist into the
round recess of the light source. Before doing this, make
sure that the top screw is unscrewed so that the fiber mist
fits properly into the recess.
2. Make sure that the fiber mist is as far as possible in the
round recess. You may need to wiggle the fiber mist from
side to side to make sure it is pushed into both the inner
and outer ring
3. 3. Tighten the top screw to lock the fiber mist into the light
source.
Step 3:
Unpack the power adapter and choose the correct connection for your country of choice. Do this by
first attaching one side of the plug connection of your choice and then sliding it to the end point and
clicking it into place.
Step 4:
Connect the connector at the end of the power adapter to the power
connector of the light source.

Step 5:
Plug the power adapter into the wall outlet.
Step 6:
Switch on the light source with the on / off push button.
10. How to use
ON/OFF Rest/ Switch- USB (not used)
Torque input
ON/OFF: Use this button to turn the light source on and off.
Rest: Short press this button to stop the colour change. Press again to resume the
colour change.
Torques: Press and hold the button for 7 seconds until the light source starts flashing
PINK. The unit is now in “PAIRING MODE”. In this mode it will slowly flash
PINK until it receives a pairing signal from the Nenko Interactive Colour
Switch (22009). Press again for 7 seconds to cancel “PAIRING MODE”
Switch input: Same function as PAUSE / PAUSE button, only performed by play switch with
3.5mm jack connection (not included). Ask for the possibilities
USB: Currently this input is not used / not preprogrammed.

11. Related products
In combination with the use of the Nenko Interactive Colour Switch
Panel (22009), the colour of the light source changes when one of the
6 push buttons on the switch panel is pressed. You can operate
multiple items with this switch panel.
For more information, please visit our website www.nenko.com.