network AD0108Q User manual

AD0108Q
AES/EBU DIGITAL AUDIO DISTRIBUTOR - 1x8 QUAD
Product Manual
Rev. 2

AD0108Q Rev. 2
Network Electronics ASA
Thorøya
P.O. Box 1020
Sandefjord, Norway
Phone: [phone]
Fax: [phone]
E-mail: [email protected]
www.network-electronics.com
Service Phone: [phone]
Revision history
Current revision of this document is the uppermost in the table below.
Revision Replaces Date Change description
2 1 23/11/04
Removed reference to discontinued product
V0106D.
1 0 01/04/04
Updated warranty description, and combined D and
Q.
0 - 10/10/00 Initial Revision.
2

AD0108Q Rev. 2
Contents
Revision history............................................................................... 2
1 Product overview......................................................................... 4
2 Specifications .............................................................................. 5
2.1 Technical specifications ...............................................................................5
2.2 Rear view.....................................................................................................5
2.3 Power connection........................................................................................5
3 Connections ................................................................................ 7
3.1 Balanced inputs ...........................................................................................7
3.2 Connecting unbalanced audio signals .........................................................7
3.3 Outputs .......................................................................................................7
4 Gain adjustment.......................................................................... 8
General environmental requirements for Network Electronics
equipment ..................................................................................... 9
Certificate of Conformity .............................................................. 10
Product Warranty ......................................................................... 11
3

AD0108Q Rev. 2
1 Product overview
The AD0108Q is a 1 to 8 AES/EBU digital audio distribution amplifier in a
single rack space ultra low profile enclosure. High performance amplifier
circuits in SMD technology give maximum signal quality and minimum jitter,
which makes this amplifier the first choice for demanding distribution tasks.
The AD0108Q provides both balanced 110 Ohm and unbalanced 75 Ohm
inputs.
4

AD0108Q Rev. 2
2 Specifications
2.1 Technical specifications
Signal type: AES/EBU digital audio (Stereo)
Signal amplitude: 0,2 – 7Vp-p
Balanced inputs: 4x transformer coupled AES3-110
Connector: DB25 female
Unbalanced inputs: 4x 75Ohm 1Vp-p unbalanced coax, SMPTE 276M
Connector: RCA
Impedance: 75 Ohm
Signal amplitude: 4Vp-p ± 1Vp-p
Outputs: 4x8 AES3-110
Connector: DB25 female
Impedance: 110 Ohm
Signal amplitude: 100mVp-p to 1Vp-p
Jitter: 0,7ns
Sampling rates: 32 – 48 kHz
AC power: External power supply 100 – 260 VAC
Dimensions: 483 x 44 x 40 mm (19”, 1RU)
2.2 Rear view
Unbalanced inputs (Balanced) inputs 1 - 4
Power connector Balanced/Unbalanced switch Output 1 - 4
2.3 Power connection
Do not connect mains to the desktop power supply before connecting
the power supply to the distributor.
Connect the DB9 female connector from the desktop power supply to the
main unit. Tighten the screws to assure a proper contact. To connect mains to
the desktop power supply you need a mains cord with IEC 320 connector.
AD0108Q is normally delivered with the desktop power model AC ±5V /
10W. Upon customer request, AD0108Q can also be delivered with DC ±5V /
30W, which may be fed by a 36 - 72 VDC mains power source. A Frame
mounted power supply solution is also available.
5

AD0108Q Rev. 2
Please refer to the latest Network Product Catalogue for power supply types,
or call the Network Electronics ASA for this information.
AD0108Q requires ±5V DC with a minimum current of 250mA. The following
pin-out is used on the DB9 male power connector:
Pin #1 0V
Pin #2 +5V
Pin #6 -5V
6

AD0108Q Rev. 2
3 Connections
3.1 Balanced inputs
Below you will find the pin-out for the DB25 audio contact marked with
INPUT. Tascam and Fostex use the same standard.
DB25 Pin #
Channel # Hot (+) Cold (-) GND
1 24 12 25
2 10 23 11
3 21 9 22
4 7 20 8
All audio contacts on the distributor are female type.
3.2 Connecting unbalanced audio signals
You may connect unbalanced AES/EBU signals via the RCA connectors. On the
input where the unbalanced signal shall be applied the Dipswitch beside the
input section need to be switched in position UNBAL. Please do not apply any
unterminated cable to the balanced input, when using the same input with
unbalanced signal. This might cause reflections and distortion on the AES
signal.
3.3 Outputs
Below you will find the pin-out for the DB25 audio contact marked with
OUTPUT1 - 4. Tascam and Fostex use the same standard.
DB25 Pin #
Channel # Hot (+) Cold (-) GND
1 24 12 25
2 10 23 11
3 21 9 22
4 7 20 8
5 18 6 19
6 4 17 5
7 15 3 16
8 1 14 2
All audio contacts on the distributor are female type.
7

AD0108Q Rev. 2
4 Gain adjustment
The AD0108Q offers gain adjustment for each input. Signal level can be
adjusted from –6dB to +6dB.
8

AD0108Q Rev. 2
General environmental requirements for Network Electronics
equipment
1. The equipment will meet the guaranteed performance specification under the
following environmental conditions:
- Operating room temperature range: 0°C to 45°C
- Operating relative humidity range: < 95% (non-condensing)
2. The equipment will operate without damage under the following environmental
conditions:
- Temperature range: -10°C to 55°C
- Relative humidity range: < 95% (non-condensing)
3. Electromagnetic compatibility conditions:
- Emissions: EN 55103-1 (Directive 89/336/EEC)
- Immunity: EN 55103-2 (Directive 89/336/EEC)
- Electrical safety: EN 60 950
With reference to the declaration of conformity provided with the external power
supply.
9

AD0108Q Rev. 2
Certificate of Conformity
Network Electronics ASA
N-3204 Sandefjord
Norway
Company Registration Number:
NO 976 584 201 MVA
Declares under sole responsibility that the product:
Product Name: AD0108Q
Product Description: AES/EBU Digital Audio Distributor -
1x8 Quad
To which this declaration relates are of Norwegian origin and are in conformity with
the following standards:
EN 55103-1: 1996 Generic Emissions Standard
EN 55103-2: 1996 Generic Immunity Standard
IEC 60950, 2nd Ed, 1991 + Amd. 1, 1992 +
Amd. 2, 1993 + Amd. 3, 1995 + Amd. 4, 1996
Safety Standard
10

AD0108Q Rev. 2
11
Product Warranty
The warranty terms and conditions for the AD0108Q follow the General Sales
Conditions by Network Electronics ASA. These conditions are available on the
company web site of Network Electronics ASA:
www.network-electronics.com