New England Arbors Bloomsbury User manual

1. Pre-Assembled SideWall Panels with Posts Connected (2) - 14041
2. Floor Panels (4) - 14042
3. Floor Support (1) - 14043
4. Front and Back Wall Panels (2) - 14044
5. Pre-assembled Shelf (1) - Shelf Board 14045, Shelf Rail 14046
6. Post Caps (4) - 14047
7. 1 1/2”(38mm) Stainless Steel Screws (32) - 20031
General Information
•Read Instructions through carefully before beginning assembly.
•When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
•We recommend an area approx 4’x 8’ (1.2 m x 2.4 m)for unobstructed assembling.
•You should not need to use excessive force when assembling components.
The Bloomsbury Raised Planter Box
Please read through before starting assembly.
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST) .
(UK Tel: [phone] - Mon. to Fri. 1:00 PM to 10:00 PM GMT).
ASSEMBLY INST RUCTIONS
7
1
Not to Scale
1
4
3
2
Ver 2.3/082117
5
6
www.newenglandarbors.com
www.newenglandarbors.co.uk
24 in
(61 cm)
36 in
(91 cm)
35 3/8 in
(90 cm)
Planter Box Dimensions are 32”L x 20”W x 10”D (81 cm L x 51 cm W x 25 cm D)
(± 3.7 cubic feet (0.1 cubic Meter) / 0.14 cubic yards / 105 litres)

The Bloomsbury Raised Planter Box
3
2
2
ST EP ONE
Align and insert pre-assembled bottom shelf into the routed holes.
Do the same for the front and back panels as shown.
Note: Only one side of the shelf rails will bottom out on the post.
This is designed to accomodate the attachment of the extension
kit (sold separately)
Align and insert the second Pre-Assembled Side Wall Panel as
shown.
Stand the planter box up and fasten the shelf rails to the posts using
8 of the screws provided through the pre-drilled holes as shown.
1
The Bloomsbury Raised Planter Box
1
2
3

The Bloomsbury Raised Planter Box
6
3
5
ST EP ONE (CONT’D)
Fasten the top of the walls together using 8of the screws
provided into the 4 upper corner brackets as shown.
Fasten the bottom corner of the wall panels together using 16 of the
screws provided into the 8 corner brackets as shown.
4
ST EP T WO
4
5
The Bloomsbury Raised Planter Box
Insert the floor support rail into the front and rear walls as shown.
Note the notch at the ends of the floor support rail.
6

The Bloomsbury Raised Planter Box
4
8
ST EP TWO (CONT’D)
Place the four floor panels onto the floor supports as shown.
Note the notches on the one side of the end panels. The notches
are to wrap around the posts.
Pressure fit the Post Caps into place. Push firmly until they snap into
place.
NOTE: If you purchased the Bloomsbury Trellis, leave 2 Post Caps
off one of the 36" (91 cm) sides to allow the trellis to be mounted.
7
8
7
Notch
Notch
www.newenglandarbors.com
www.newenglandarbors.co.uk
North America Toll Free Phone: [phone]
United Kingdom Tel: [phone]