FRAME IT ALL 300001058 User manual

300001058/300001080/300001084/300001061
300001424/300001425/300001426/300001427
300001514
RAISED GARDEN BED
4’ x 4’
1 LEVEL KIT CONTAINS:
Customer Service: 1800-914-9835 | [e-mail]
© 2020 Frame It All. All Rights Reserved.
Composite
Timbers x 4
Stacking
Brackets x 8
Tools needed: Hammer (to tap stake in place), Hackshaw (optional)
Stake x 4
Plugs x 16
Caps x 4
2 LEVELS KIT CONTAINS:
Composite
Timbers x 8
Stacking
Brackets x 16 Stake x 8
Plugs x 32
Caps x 4
1 LEVEL 2 LEVELS
Layout your timbers along
the borderline and
connect each timber
together by inserting the
top of the stake through
the bracket loops with the
stake pointing to the sky.
This enables you to freely
position your border to
get your desired location.

Customer Service: 1800-914-9835 | [e-mail]
ASSEMBLY INSTRUCTIONS
STEP 1:
For one level, assemble 4 x Doubled-Bracket Timbers (A)
For two levels, assemble 8 x Doubled-Bracket Timbers (A)
Attach one single stacking bracket to each end of timbers (one facing up, one facing
down – shown above)
STEP 2: Layout the base level of your raised garden in a straight square shape, using 4
(A) timbers. Insert Stake through the hole of the bracket and into each of the corners
to lock all sides in place.
X 4
X 8
Use plugs (included)
to cover the holes on
both side of timbers
X 4
STEP 2a: For one level, add caps to
each of the top corner joints to finish
off the raised garden and plugs to cover
the holes on both side of timbers.
HAPPY GARDENING!
Note:
If you plan to assemble raised bed on a hard surface, use
hacksaw to remove the spike of each stake. Use these cut
down stakes for the base level only of your raised garden.
Trim stake spike with
hacksawfor use indoor
or on hard surfaces

Customer Service: 1800-914-9835 | [e-mail]
ASSEMBLY INSTRUCTIONS – For Product with Second Level only
STEP 3: For the second level, use 4 (A) timbers and the stacking stakes. Insert one
stake through the brackets into the hole on top of the stake beneath it to lock the
second level in place.
STEP 4: Add the caps to each of the top corner joints and plugs to cover the holes on
both side of timbers.
X 4
Use plugs (included)
to cover the holes on
both side of timbers
Use plugs to cover
the holes – two
plugs are required
per bracket (1 on
each side)
Use a Finishing
Cap to complete
the top level.
Use an Anchor
or Stacking Joint
for ground level
frames or borders.
Use only Stacking
Joints when
creating additional
levels.
When creating a
multi-level frame
use a Stacking
Joint.
Stacking Joints fitinto
the tops of Anchor
Joints and other
Stacking
Joints
How the Joints Work