New England Arbors Cardiff Planter Box User manual

1. Pre-Assembled Side Wall Panels (2) - 10812
2. Pre-Assembled Front & Back Wall Panels with Posts Connected (2) - 10811
3. Post Caps (4) - 10810
4. Floor Boards (3) - 10813
5. Base Trim (4) - 10730-1
General Information
•Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ (1.2 m x 2.4 m) for unobstructed assembling.
•You should not need to use excessive force when assembling components.
The Cardi Planter Box
Please read through before starting assembly.
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
(UK Tel: [phone] (Mon. to Fri. 8~1:00 PM to 10:00 PM GMT).
ASSEMBLY INSTRUCTIONS
1
1
4
3
2
V1.3/072417
15.75 in
40 cm
15 in
38 cm
12 in
30.5 cm
13.75 in
35 cm
16 in
41 cm
16 in
41 cm
5
www.newenglandarbors.com
www.newenglandarbors.co.uk

STEP T WO
Install the four Post Caps and Base Trims. Push post caps until the
locking tabs snapsinto place.
Install Post Caps
5
3
North America Toll Free Phone: [phone]
United Kingdom Tel: [phone]
www.newenglandarbors.com
www.newenglandarbors.co.uk
Insert the three floor boards into the pre-routed hole.
Align and insert the pre-assembled back panel to the side wall
panels. Ensure the bottom slats are also inserted into the pre-
routed hole. Push until the locking tabs snap into place.
3
4
2
4
5
STEP ONE
Lay out front wall panel on the work surface.
Insert the side walls into the routed holes on the front wall
panel postsuntil rails bottom out. Push until the locking tabs
snap into place.
Connect the Front & Back Wall
to the Side Wall Panels
1
2
1
2