New England Arbors The Cambridge Raised Planter Box User manual

Check Box for These Contents
In the event of missing or defective parts please call our customerservice dept. at 1800 282 9346 (Mon. to Fri.8:00 AM to 4:00 PM EST).
1. Pre-Assembled Side Wall Panels with Posts Connected (2)
2. Floor Panels (4)
3. Floor Support (1)
4.
Front and Back Wall Panels (2)
5. Pre-assembled Shelf (1)
6. Post Caps (4)
7. 5/8” Stainless Steel Screws (12)
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e.shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ for unobstructed assembling.
• You should not need to use excessive force when assembling components.
The Cambridge Raised Planter Box
Please read through before starting assembly.
ASSE M B LY INSTRUCTIONS
7
1
Not to Scale
1
4
3
2
Ver 3.2/101515
5
6
www.newenglandarbors.com
8. 1 1/2”Stainless Steel Screws (8)
8

The Cambridge Raised Planter Box
3
2
2
1
STE P O NE
Lay the Pre-Assembled Side Wall Panel on the floor as shown and
align and insert the pre-assembled shelf into the routed hole.
Do the same for the Front and Back Wall Panels as shown.
This is designed to accomodate the attachment of an extension kit
(sold separately).
Align and insert the second Pre-Assembled Side Wall Panel as
shown.
Stand the planter box up. Center the shelf within the side panel posts
and fasten the shelf rails to the posts using 8 of the 5/8” screws provided
through the pre-drilled holes as shown.
The Cambridge Raised Planter Box
www.newenglandarbors.com
1
2
3

The Cambridge Raised Planter Box
6
3
5
STEP O N E (CO N T ’ D )
Fasten the wall panels together using 4 of the 5/8” screws provided
through the pre-drilled holes on the posts as shown.
Fasten the corner brackets to the posts using 8 of the 1 1/2”screws
provided through the pre-drilled holes on the brackets as shown.
4
www.newenglandarbors.com
STE P T WO
4
5
The Cambridge Raised Planter Box
Insert the floor support rail into the front and rear walls as shown.
Note the notch at the ends of the floor support rail.
6

The Cambridge Raised Planter Box
Toll Free Phone: [phone] Toll Free Fax: [phone]
www.newenglandarbors.com
4
8
STE P T W O ( CONT’D)
Place the four floor panels onto the floor supports as shown.
Note the notches on the one side of the end panels. The notches
are to wrap around the posts.
Pressure fit the Post Caps into place. Push firmly until they snap
into place.
7
www.newenglandarbors.com
8
7
Notch
Notch