Nexans N42i.900 User manual

N42i.900 termination instruction
LANmark Industry Field Terminable Plug Cat 6A
September 2017 - V1.02

N42i.900 termination instructions
2I Nexans Cabling Solutions - Installation is to performed by qualified personnel - www.nexans.com/LANsystems - [e-mail]
1. Slip the cover on the end of the cable.
Also see assembly instructions printed in the box. 2. Remove 2.5 cm of the jacket. 3. Remove 1.5 cm of the foil.
4. Pull back the pairs to expose the plastic cross. 5. Cut-off the plastic cross as close to the jacket as possible
(without damaging the wires) - using flush side cutters.

N42i.900 termination instructions
3I Nexans Cabling Solutions - Installation is to performed by qualified personnel - www.nexans.com/LANsystems - [e-mail]
6. Insert the green and blue pairs into the
lower part of the plug (keeping the untwist of
the pairs, between the jacket and plug, to a
minimum).
7. Insert the brown and orange pairs into the upper
Part of the plug (keeping the untwist of the pairs,
between the jacket and plug, to a minimum).
Cut the wires flush as shown on the instructions printed inside the box
8. Ensure the foil is put back around the pairs.
Wind the drain wire around the foil.
9. Close the connector to crimp the wires.
Install the 360° shield on the underside of the connector. 10. Slide the cover over the connector (a) and tighten-up the gland (b).
a.
b.