Next ART PLINTH User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
by-step instructions.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found to be
faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ART PLINTH
by-step instructions.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• Do not rub or scrub the surface when cleaning.
PRODUCT INFORMATION
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent scratching or
damage.
• Do not put hot dishes directly on the surfaces of the item.
• Do not use furniture polish.
CARE INSTRUCTIONS
• Made in China
• Made from PB, hollow board & Honeycomb board with a wood foil finish.
• For general cleaning, periodically dust with a soft cloth.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• Carefully check that you have all parts before beginning assembly.
Page 1 of 3

1. Insert 4× cambolts (C) into panel 1 by
a screwdriver until tight.
PARTS
STEP ONE
FITTINGS
1. Glue and insert 4×wooden dowels (A) into
panel 1 , and attach the panels 2 (X2) to
panel 1.
2. Insert 4×camlocks ( D ) into the panels 2 (X2) .
Ensuring the arrow indicator is pointing
towards the panel edge and turn camlocks
clockwise until tight by a screwdriver.
STEP TWO
Page 2 of 3

1, Attach panel 3 to panels 2 (X2) with
6×screws (E) by an Allen key (F)
1.Glue and insert 4× wooden dowels (A) into
panel 3 , and attach panel 4 to panel 3 .
STEP THREE
STEP FOUR
1.Apply 4× floor protectors (G) to the bottom panel 4.
2.Use 4× stickers (H) to cover holes on panels 2.
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
STEP FIVE
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
Page 3 of 3