Next OPUS User manual

Tools Needed
Helpline
If you have any problems with this product or require any
replacement fittings please contact Customer Services
Tel: [phone]
by-step instructions.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of two persons is required to assemble this product.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found to be
faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-
• Carefully check that you have all parts before beginning assembly.
• For general cleaning, periodically dust with a soft cloth.
PRODUCT INFORMATION
• Made from MDF & partical board with a wood effect finish.
CARE INSTRUCTIONS
• Made in China
• Do not put hot dishes directly on the surfaces of the item.
• Do not use furniture polish.
• Do not rub or scrub the surface when cleaning.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent scratching or
damage.
OPUS TALL CORNER SHELVES
Page 1 of 6

1. Stand and spread the frame fully as illustrated.
NB: The spreadable angle for the frame can't
exceed 90 degree.
1. Attach panels (2),(3),(4),(5)&(6) to the frame
with 20×screws (A) by an allen key (B) until tight.
Please note:Screw all the panels in one side of frame
first then continue assembling the panels to the other
side of the frame.
1. Use 20×stickers (C) to cover the screw holes.
STEP ONE
FITTINGS
PARTS
STEP THREE
STEP TWO
Page 2 of 6

1. Using screws and washers provided secure the
2×nylon stability straps (D) to the top of back panel.
2. Secure the other end of the strap to the wall with
an appropriate screw and wall plug for your wall
type (not provided).
NB: To hide the strap behind the unit, drill the
hole lower than the top of the unit.
Warning:Always ensure intended wall area to be
drilled is free from hidden electrical wires,
water and gas pipes.
NB: Wall fixings are not included, please source
suitable fixings for your wall type if in doubt,
please consult a qualified tradesperson.
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
STEP FOUR
Page 3 of 6

• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of two persons is required to assemble this product.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found to be
faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-
• Carefully check that you have all parts before beginning assembly.
• For general cleaning, periodically dust with a soft cloth.
PRODUCT INFORMATION
• Made from MDF & partical board with a wood effect finish.
CARE INSTRUCTIONS
• Made in China
• Do not put hot dishes directly on the surfaces of the item.
• Do not use furniture polish.
• Do not rub or scrub the surface when cleaning.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent scratching or
damage.
OPUS TALL CORNER SHELVES
Page 4 of 6

1 st 2nd
STEP ONE
FITTINGS
PARTS
STEP THREE
STEP TWO
Page 5 of 6

Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
STEP FOUR
Page 6 of 6