Next PRIMROSE 427044 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
•All assembly xings should always be tightened properly and periodically check all xings and tighten if necessary.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaet and then follow the simple step by step instructions.
• Carefully check that you have all parts before beginning assembly.
• Keep ttings out of children's reach and keep children well away from the construction area.
•Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or warping.
• Never drag pieces of furniture across the oor as this will cause damage to the joints.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
PRODUCT INFORMATION
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 adults is required to assemble this product.
• Do not use abrasive cleaning products or those containing silicone.
• Made in China.
•A mattress measuring 90cm x 190cm is intended for use with this bed.
CARE INSTRUCTIONS
• For general cleaning, periodically dust with a soft cloth.
• Do not rub or scrub the surface when cleaning.
427044 PRIMROSE METAL BED - SINGLE
Page 1 of 3

1. Insert 14 x slats 4 into the slat holes of the strap
assembly 6. Ensure the curve of the slats are facing
upwards.
1. Attach 28 x plastic caps 5 onto both ends of each
slat of the wooden slat assembly. Ensure the curve of
the slats are facing upwards with the pins in the caps
facing downwards.
FITTINGS
STEP ONE
PARTS
STEP TWO
Page 2 of 3

1. Attach headboard 1 and footboard 2 to 2 x side
rails 3 with 8 x bolts (A), 8 x washers (B) and 8 x
rubber washers (C), using Allen key (D) to tighten.
1. Insert plastic end caps 5 of the wooden slat
assembly into the holes in side rails 3. Ensure the
curves of the slats are facing upwards.
STEP THREE
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
STEP FIVE
STEP FOUR
Page 3 of 3