Nice X-BAR barrier User manual

X-BAR barrier operation manual Enclosure
E.62
Rev 4.00
In conformity with the Machinery Directive 2006/42/EC and applicable parts of the EN standards EN 13241-1; EN 12453; EN 12445; EN 12635 01/09/2010
Gearmotor manual release and locking: The gearmotor is equipped with a mechanical system that enables manual opening
and closing of the pole. These operations are required in the event of a power failure or malfunctions.
IMPORTANT!
– The gearmotor release and locking operations must be performed only when the pole is horizontal and stationary.
– The gearmotor can be released manually on both sides of the barrier.
01. Unscrew the key cover (Fig. B-1);
02. Insert the key supplied and turn through 180° (Fig. B-2);
03. Move the pole as required (Fig. B - 3);
04. To lock the gearmotor, rotate the key through a further 180°.
Document produced by Nice S.p.a. for installers – All rights reserved Page ____ of ______

Safety devices disabled: the barrier can be operated even when the safety device on the barrier do not work correctly.
- Activate the barrier command (with the transmitter or key-operated selector switch, etc.); if all is in working order, the pole opens
or closes normally; otherwise the flashing light emits a number of flashes and the manoeuvre is not started (the number of flashes
depends on the reason for which the manoeuvre does not start).
- In this case, the user must press and hold the command within three seconds.
- After approx. 2 seconds the barrier will start to operate in “hold-torun” mode, i.e. the pole will continue to move while the
command is activated; THE POLE STOPS AS SOON AS THE COMMAND IS RELEASED.
If the safety devices are out of service, the automation must be repaired as soon as possible.
Edge light replacement: to replace the lamp on the control unit it is important to first disconnect X-Bar from any electrical power
sources (including the buffer battery), after which proceed as shown; replace the lamp with a version of the same specifications
(12 V / 10 W - BA15S fitting).
Disposal: At the end of the automation’s lifetime, ensure that it is disposed by qualified personnel and that the materials are
recycled or scrapped according to current local standards.
Document produced by Nice S.p.a. for installers – All rights reserved Page ____ of ______