Nokia BH 102 - Headset - Over-the-ear User manual

Nokia Bluetooth Headset BH-102
1
10
11
9
8
7
2
3
1
4
5
44
4
6
Issue

2
2 © 2008 Nokia. All rights reserved.
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares
that this HS-107W product is in
compliance with the essential
requirements and other relevant
provisions of Directive 1999/5/EC. A
copy of the Declaration of Conformity
can be found at http://www.nokia.com/
phones/declaration_of_conformity/.
© 2008 Nokia. All rights reserved.
Nokia and Nokia Connecting People are
registered trademarks of Nokia
Corporation. Other product and
company names mentioned herein may
be trademarks or tradenames of their
respective owners.
Reproduction, transfer, distribution, or
storage of part or all of the contents in
this document in any form without the
prior written permission of Nokia is
prohibited.
Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
Nokia operates a policy of ongoing
development. Nokia reserves the right to
make changes and improvements to any
of the products described in this
document without prior notice.
To the maximum extent permitted by
applicable law, under no circumstances
shall Nokia or any of its licensors be
responsible for any loss of data or
income or any special, incidental,
consequential or indirect damages
howsoever caused.
The contents of this document are
provided "as is". Except as required by
applicable law, no warranties of any
kind, either express or implied,
including, but not limited to, the implied
warranties of merchantability and
fitness for a particular purpose, are
made in relation to the accuracy,
reliability or contents of this document.
Nokia reserves the right to revise this
document or withdraw it at any time
without prior notice.
The availability of particular products
may vary by region. Please check with
your Nokia dealer for details.

© 2008 Nokia. All rights reserved. 3
Export controls
This device may contain commodities,
technology or software subject to export
laws and regulations from the US and
other countries. Diversion contrary to
law is prohibited.
Introduction
With the Nokia Bluetooth Headset
BH-102, you can make and receive
calls while on the move. You can
use the headset with compatible
phones that support Bluetooth
wireless technology.
Read this user guide carefully
before using the headset. Also,
read the user guide for your phone.
It provides important safety and
maintenance information. Keep
the headset out of the reach of
small children.
Bluetooth wireless
technology
Bluetooth wireless technology
allows you to connect compatible
devices without cables. The phone
and the headset do not need to be
in line of sight, but they should be
within 10 metres (33 feet) of each
other. Connections may be subject
to interference from obstructions,
such as walls, or other electronic
devices.
The headset complies with the
Bluetooth Specification 2.0 + EDR
that supports the Headset Profile
1.1 and Hands-Free Profile 1.5.
Check with the manufacturers of
other devices to determine their
compatibility with this device.

4
4 © 2008 Nokia. All rights reserved.
Get started
The headset contains the
following parts shown on the title
page: earloop (1), charger
connector (2), earpiece (3), blue
indicator light (4), multifunction
key (5), and microphone (6).
Before using the headset, you
must charge the battery and pair
the headset with a compatible
phone.
Parts of the device are magnetic.
Metallic materials may be attracted
to the device. Do not place credit
cards or other magnetic storage
media near the device, because
information stored on them may be
erased.
Chargers
This device is intended for use when
supplied with power from the
following chargers: AC-3, AC-4,
AC-5, and DC-4.
Warning: Use only
chargers approved by
Nokia for use with this
particular enhancement. The use of
any other types may invalidate any
approval or warranty, and may be
dangerous.
When you disconnect the power cord
of any enhancement, grasp and pull
the plug, not the cord.
Charge the battery
Before charging the battery,
carefully read “Battery
information”.
1. Connect the charger to a wall
outlet.
2. Connect the charger cable to
the charger connector (8). The
indicator light is on during

© 2008 Nokia. All rights reserved. 5
charging. Charging the battery
fully may take up to 2 hours.
3. When the battery is fully
charged, the indicator light
turns off. Disconnect the
charger from the headset and
the wall outlet.
The fully charged battery has
power for up to 10 hours of talk
time or up to 250 hours of standby
time.
When battery power is low, the
headset beeps once every minute
and the indicator light flashes
quickly.
Switch on or off
To switch on, press and hold the
multifunction key for about 2 to 4
seconds. The headset beeps, and
the indicator light is displayed. The
headset tries to connect to a
paired device.
To switch off, press and hold the
multifunction key for about 4 to 8
seconds.
Pair the headset
1. Ensure that your phone is
switched on and the headset is
switched off.
2. Press and hold the
multifunction key (for about 4
to 8 seconds) until the
indicator light starts to flash
quickly.
3. Activate the Bluetooth feature
on the phone, and set the
phone to search for Bluetooth
devices.
4. Select the headset from the list
of found devices.
5. Enter the passcode 0000 to
pair and connect the headset to
your phone. In some phones,
you may need to make the

6
6 © 2008 Nokia. All rights reserved.
connection separately after
pairing. You only need to pair
the headset with your phone
once.
If the pairing is successful, the
headset appears in the phone
menu where you can view the
currently paired Bluetooth
devices.
When the headset is connected to
your phone and is ready for use,
the indicator light flashes slowly.
Basic use
Put on the headset
To use the headset on your right
ear, attach the earloop as shown in
Figure 7; to use the headset on
your left ear, attach the earloop
from the other side. Slide the
earloop over your ear (9), and
gently push the earpiece into your
ear. Point the headset towards
your mouth (10).
Call handling
To make a call, use your phone in
the normal way when the headset
is connected to your phone.
To redial the number you last
called (if your phone supports this
feature with the headset), when
no call is in progress, press the
multifunction key twice.
To activate voice dialling (if your
phone supports this feature with
the headset), when no call is in
progress, press and hold the

© 2008 Nokia. All rights reserved. 7
multifunction key for about 2 to 4
seconds. Proceed as described in
the phone user guide.
To answer or end a call, press the
multifunction key. To reject a call,
press this key twice.
To adjust the volume during a call,
use the phone volume keys.
To switch a call between the
headset and a compatible phone,
press and hold the multifunction
key for about 2 to 4 seconds.
Clear settings or reset
To delete the pairings from the
headset, switch off the headset,
and press and hold the
multifunction key for over 8
seconds until the headset beeps
twice and the indicator light
flashes quickly.
To reset the headset if it stops
functioning, even though it is
charged, plug the headset into a
charger.
Troubleshooting
If you cannot connect the headset
to your compatible phone, check
that the headset is charged,
switched on, and paired with your
phone.
Battery information
This device has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device as you may damage
the device. The battery can be
charged and discharged hundreds of
times, but it will eventually wear out.
Recharge your battery only with
Nokia approved chargers designated
for this device. Use of an unapproved

8
8 © 2008 Nokia. All rights reserved.
charger may present a risk of fire,
explosion, leakage, or other hazard.
If a battery is being used for the first
time or if the battery has not been
used for a prolonged period, it may be
necessary to connect the charger,
then disconnect and reconnect it to
begin charging the battery. If the
battery is completely discharged, it
may take several minutes before the
charging indicator light is displayed.
Unplug the charger from the
electrical plug and the device when
not in use. Do not leave a fully
charged battery connected to a
charger, since overcharging may
shorten its lifetime. If left unused, a
fully charged battery will lose its
charge over time.
Always try to keep the battery
between 15°C and 25°C (59°F and
77°F). Extreme temperatures reduce
the capacity and lifetime of the
battery. A device with a hot or cold
battery may not work temporarily.
Battery performance is particularly
limited in temperatures well below
freezing.
Do not dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged.
Never use any charger that is
damaged.
Important: Battery talk
and standby times are
estimates only and
depend on network conditions,
features used, battery age and
condition, temperatures to which
battery is exposed, and many other
factors. The amount of time a device
is used for calls will affect its standby
time. Likewise, the amount of time
that the device is turned on and in
the standby mode will affect its talk
time.

© 2008 Nokia. All rights reserved. 9
Care and maintenance
Your device is a product of superior
design and craftsmanship and should
be treated with care. The following
suggestions will help you protect
your warranty coverage.
• Keep the device dry. Precipitation,
humidity, and all types of liquids
or moisture can contain minerals
that will corrode electronic
circuits. If your device does get
wet, allow it to dry completely.
• Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can
be damaged.
• Do not store the device in hot
areas. High temperatures can
shorten the life of electronic
devices, damage batteries, and
warp or melt certain plastics.
• Do not store the device in cold
areas. When the device returns to
its normal temperature, moisture
can form inside the device and
damage electronic circuit boards.
• Do not attempt to open the
device.
• Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
• Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the device.
• Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
If the device is not working properly,
take it to the nearest authorised
service facility for service.