Nokia BH 212 - Headset - Over-the-ear User manual

Nokia Bluetooth Headset BH-212
9209766/2
7
35
44 6
11
9
8
2
1

ENGLISH
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares that
this HS-112W product is in compliance with
the essential requirements and other
relevant provisions of Directive 1999/5/EC. A
copy of the Declaration of Conformity can be
found at http://www.nokia.com/phones/
declaration_of_conformity/.
© 2008 Nokia. All rights reserved.
Nokia, Nokia Connecting People and the
Nokia Original Accessories logo are
registered trademarks of Nokia Corporation.
Other product and company names
mentioned herein may be trademarks or
tradenames of their respective owners.
Reproduction, transfer, distribution, or
storage of part or all of the contents in this
document in any form without the prior
written permission of Nokia is prohibited.
Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
Nokia operates a policy of ongoing
development. Nokia reserves the right to
make changes and improvements to any of
the products described in this document
without prior notice.
To the maximum extent permitted by
applicable law, under no circumstances shall
Nokia or any of its licensors be responsible
for any loss of data or income or any special,
incidental, consequential or indirect
damages howsoever caused.
The contents of this document are provided
"as is". Except as required by applicable law,
no warranties of any kind, either express or
implied, including, but not limited to, the
implied warranties of merchantability and
fitness for a particular purpose, are made in
relation to the accuracy, reliability or
contents of this document. Nokia reserves
the right to revise this document or
withdraw it at any time without prior notice.
The availability of particular products may
vary by region. Please check with your Nokia
dealer for details.
Export controls
This device may contain commodities,
technology or software subject to export
laws and regulations from the US and other
countries. Diversion contrary to law is
prohibited.

ENGLISH
Introduction
With the Nokia Bluetooth Headset
BH-212, you can make and receive
calls while on the move. You can use
the headset with compatible mobile
phones that support Bluetooth
wireless technology.
Read this user guide carefully before
using the headset. Also, read the user
guide for your phone.
This product may contain small parts.
Keep them out of the reach of small
children.
Bluetooth wireless technology
Bluetooth wireless technology allows
you to connect compatible devices
without cables. The phone and the
headset do not need to be in line of
sight, but they should be within 10
metres (33 feet) of each other.
Connections may be subject to
interference from obstructions, such
as walls, or other electronic devices.
The headset is compliant with the
Bluetooth Specification 2.0 + EDR
supporting the Headset Profile 1.1 and
Hands-Free Profile 1.5. Check with the
manufacturers of other devices to
determine their compatibility with
this device.
Get started
The headset contains the following
parts shown on the title page: volume

ENGLISH
key (1), multifunction key (2),
indicator light (3), charger connector
(4), earpiece (5), and microphone (6).
Before using the headset, you must
charge the battery and pair the
headset with a compatible phone.
Parts of the device are magnetic. Metallic
materials may be attracted to the device.
Do not place credit cards or other
magnetic storage media near the device,
because information stored on them may
be erased.
Chargers
This device is intended for use when
supplied with power from the following
chargers: AC-3, AC-4, AC-5, and DC-4.
Warning: Use only chargers
approved by Nokia for use
with this particular
enhancement. The use of any other types
may invalidate any approval or warranty,
and may be dangerous.
When you disconnect the power cord of
any enhancement, grasp and pull the
plug, not the cord.
Charge the battery
Before charging the battery, carefully
read “Battery information”.
1. Connect the charger to a wall
outlet.
2. Connect the charger to the headset
(7). During charging, the red
indicator light is on and the
headset cannot be used. Charging
the battery fully may take up to 2
hours.
3. When the battery is fully charged,
the green indicator light is
displayed. Disconnect the charger
from the headset and the wall
outlet.
If the headset was connected to
your phone before charging, the
headset connects to it again.

ENGLISH
The fully charged battery has power
for up to 11 hours of talk time or up to
500 hours of standby time.
When the battery is discharged, the
headset beeps every minute and the
red indicator light flashes quickly.
Switch on or off
To switch on, press and hold the
multifunction key for about 2 seconds.
The headset beeps, and the green
indicator light is displayed. The
headset tries to connect to a paired
phone.
To switch off, press and hold the
multifunction key for about 5 seconds.
The headset beeps, and the red
indicator light is briefly displayed.
Pair the headset
1. Ensure that your phone is on and
the headset is off.
2. Press and hold the multifunction
key (for about 5 seconds) until the
green indicator light starts to flash
quickly.
3. Activate the Bluetooth feature on
the phone, and set it to search for
Bluetooth devices.
4. Select the headset from the list of
found devices.
5. Enter the passcode 0000 to pair
and connect the headset to your
phone. In some phones, you may
need to make the connection
separately after pairing.
If the pairing is successful, the
headset appears in the phone menu
where you can view the currently
paired Bluetooth devices.
When the headset is connected to
your phone and is ready for use, the
green indicator light flashes slowly.

ENGLISH
Basic use
Place the headset on the ear
Place the headset over your ear, and
slide it downwards (8). Gently push
the earpiece into your ear. Point the
headset toward your mouth (9).
Calls
To make a call, use your phone in the
normal way when the headset is
connected to it.
To redial the number you last called (if
your phone supports this feature with
the headset), when no call is in
progress, press the multifunction key
twice.
To activate voice dialling (if your
phone supports this feature with the
headset), when no call is in progress,
press and hold the multifunction key
for about 2 seconds. Proceed as
described in the phone user guide.
To answer or end a call, press the
multifunction key. To reject a call,
press this key twice.
To adjust the volume during a call,
slide the volume key up or down.
To mute or unmute the microphone
during a call, briefly press the middle
of the volume key.
To switch a call from the headset to a
compatible phone, press and hold the
multifunction key for about 5 seconds
(the headset switches off). To switch
the call back to the headset, press the
multifunction key for about 2 seconds
(the headset switches on).
Clear settings or reset
To delete the pairings from the
headset or reset the headset, switch
off the headset, and press and hold
the multifunction key for over 8

ENGLISH
seconds. The headset beeps twice, and
the red and green indicator lights
alternate 5 times.
Troubleshooting
If you cannot connect the headset to
your compatible phone, check that the
headset is charged, switched on, and
paired with the phone.
Battery information
This device has an internal,
nonremovable, rechargeable battery. Do
not attempt to remove the battery from
the device as you may damage the
device. The battery can be charged and
discharged hundreds of times, but it will
eventually wear out. Recharge your
battery only with Nokia approved
chargers designated for this device. Use
of an unapproved charger may present a
risk of fire, explosion, leakage, or other
hazard.
If a battery is being used for the first time
or if the battery has not been used for a
prolonged period, it may be necessary to
connect the charger, then disconnect and
reconnect it to begin charging the
battery. If the battery is completely
discharged, it may take several minutes
before the charging indicator light is
displayed.
Unplug the charger from the electrical
plug and the device when not in use. Do
not leave a fully charged battery
connected to a charger, since
overcharging may shorten its lifetime. If
left unused, a fully charged battery will
lose its charge over time.
Always try to keep the battery between
15°C and 25°C (59°F and 77°F). Extreme
temperatures reduce the capacity and
lifetime of the battery. A device with a

ENGLISH
hot or cold battery may not work
temporarily. Battery performance is
particularly limited in temperatures well
below freezing.
Do not dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged.
Never use any charger that is damaged.
Important: Battery talk and
standby times are estimates
only and depend on network conditions,
features used, battery age and condition,
temperatures to which battery is
exposed, and many other factors. The
amount of time a device is used for calls
will affect its standby time. Likewise, the
amount of time that the device is turned
on and in the standby mode will affect its
talk time.
Care and maintenance
Your device is a product of superior
design and craftsmanship and should be
treated with care. The following
suggestions will help you protect your
warranty coverage.
• Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If your
device does get wet, allow it to dry
completely.
• Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can be
damaged.
• Do not store the device in hot areas.
High temperatures can shorten the
life of electronic devices, damage
batteries, and warp or melt certain
plastics.
• Do not store the device in cold areas.
When the device returns to its normal

ENGLISH
temperature, moisture can form
inside the device and damage
electronic circuit boards.
• Do not attempt to open the device.
• Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
• Do not use harsh chemicals, cleaning
solvents, or strong detergents to
clean the device.
• Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
These suggestions apply equally to your
device, charger, or any enhancement. If
any device is not working properly, take it
to the nearest authorised service facility
for service.
Disposal
The crossed-out wheeled-bin
symbol on your product,
literature, or packaging reminds
you that all electrical and
electronic products, batteries, and
accumulators must be taken to separate
collection at the end of their working life.
This requirement applies to the European
Union and other locations where
separate collection systems are available.
Do not dispose of these products as
unsorted municipal waste.
By returning the products to collection
you help prevent uncontrolled waste
disposal and promote the reuse of
material resources. More detailed
information is available from the product
retailer, local waste authorities, national
producer responsibility organizations, or
your local Nokia representative. For the
product Eco-Declaration or instructions
for returning your obsolete product, go to
country-specific information at
www.nokia.com.