Nokia HDW-1 User manual

User’s Guide for the Wireless
Headset (HDW-1)
9353783
Issue 2
hdw-1_2-00.fm Page 1 Wednesday, April 24, 2002 9:24 AM

DECLARATION OF CONFORMITY
We, NOKIA CORPORATION declare under our sole responsibility that the product
HDW-1 is in conformity with the provisions of the following Council Directive:
1999/5/EC.
A copy of the Declaration of Conformity can be found from
http://www.nokia.com/phones/declaration_of_conformity/.
Copyright © Nokia Corporation 2002. All rights reserved.
Reproduction, transfer, distribution or storage of part or all of the contents in this document in
any form without the prior written permission of Nokia is prohibited.
Nokia is a registered trademark of Nokia Corporation. Other product and company names
mentioned herein may be trademarks or tradenames of their respective owners.
Nokia operates a policy of continuous development. Nokia reserves the right to make changes
and improvements to any of the products described in this document without prior notice.
Under no circumstances shall Nokia be responsible for any loss of data or income or any
special, incidental, consequential or indirect damages howsoever caused.
The contents of this document are provided "as is". Except as required by applicable law, no
warranties of any kind, either express or implied, including, but not limited to, the implied
warranties of merchantability and fitness for a particular purpose, are made in relation to the
accuracy, reliability or contents of this document. Nokia reserves the right to revise this
document or withdraw it at any time without prior notice.
The availability of particular products may vary by region. Please check with the Nokia dealer
nearest to you.
9353783 / Issue 2
hdw-1_2-00.fm Page 2 Wednesday, April 24, 2002 9:24 AM

Contents
3
Contents
Introduction ............................. 4
Bluetooth wireless technology .......... 4
Chargers and batteries ......................... 5
The sticker in the sales package........ 5
1. Getting started..................... 6
Overview................................................... 6
Charging the battery ............................ 7
When the battery charge
falls low................................................. 8
Adjusting the headset to your ear .... 8
Switching the headset on or off ....... 9
Taking the headset into use
for the first time .................................... 9
Troubleshooting ................................ 10
Placing the headset on the ear........ 11
2. Using the headset .............. 12
Connecting the paired
headset to your phone ....................... 12
Making a call ........................................ 13
Voice dialling ........................................ 13
Ending a call......................................... 13
Answering a call.................................. 13
Rejecting a call.................................... 13
Automatic answer............................... 14
Redialling the last dialled number. 14
Adjusting the earphone volume ..... 14
Switching the call between
phone and headset ............................. 14
Disconnecting the headset
from the phone.................................... 15
Reconnecting the paired
headset to your phone................... 15
Using the headset with
several phones ..................................... 15
Using the headset with
several paired phones..................... 15
Resetting the headset........................ 16
3. Battery information ........... 17
Care and maintenance........... 19
hdw-1_2-00.fm Page 3 Wednesday, April 24, 2002 9:24 AM

Introduction
4
Introduction
The Wireless Headset HDW-1 can be connected without wires to a
compatible phone that supports Bluetooth wireless technology. This gives
you complete freedom for making and receiving calls while on the move
or at the office.
Read this user’s guide carefully before using the headset. More detailed
information is given in your phone’s user's guide. Do not use this Wireless
Headset (HDW-1) user’s guide in place of your phone’s user's guide, which
provides important safety and maintenance information.
■Bluetooth wireless technology
Since Bluetooth devices communicate using radio waves, your Bluetooth
phone and headset do not need to be in a line of sight. The two devices
only need to be within a maximum of 10 meters of each other, although
the connection can be subject to interference from obstructions, such as
walls, or from other electronic devices.
The headset is specially designed for Nokia phones that support Bluetooth
wireless technology. The headset can, however, be used with any
compatible Bluetooth devices that support the Handsfree profile. (Here,
"Profile" means a set of Bluetooth commands that your phone uses for
controlling the headset.)
The headset provides the best performance when it is used with a
compatible Nokia phone. If you use the headset with a phone produced by
hdw-1_2-00.fm Page 4 Wednesday, April 24, 2002 9:24 AM

Introduction
5
another manufacturer, all the functions described in this user’s guide may
not be available.
In some countries, there may be restrictions on using Bluetooth devices.
Check with your local authorities.
■Chargers and batteries
Check the model number of any charger before use with this device. The
Wireless Headset HDW-1 is intended for use with the following chargers:
ACP-7, ACP-8, ACP-9, ACP-12, LCH-8 and LCH-9.
Warning! Use only batteries and chargers approved by the phone
manufacturer for use with this particular accessory. The use of
any other types will invalidate any approval or warranty applying
to the accessory, and may be dangerous.
For availability of approved batteries and chargers, please check with your
dealer.
When you disconnect the power cord of any accessory, grasp and pull the
plug, not the cord.
■The sticker in the sales package
The sticker contains the Bluetooth passkey you need for pairing your
phone with the headset. Keep this sticker in a safe and secure place.
For using the passkey, see Taking the headset into use for the first time on
page 9.
hdw-1_2-00.fm Page 5 Wednesday, April 24, 2002 9:24 AM

Getting started
6
1. Getting started
■Overview
The headset has the
following parts.
1 - Handset ():
Answers or ends the call.
This key can also be used
for voice dialling and
switching an active call
between the headset and
the phone.
2 - Indicator light:
Shows the current status
of the headset.
3 - Volume up: Increases the earphone volume during a call.
4 - Volume down: Decreases the earphone volume during a call. To
switch the headset on or off, press and hold this key.
5 - Earphone: Relays the caller’s voice.
6 - Charger connector
7 - Microphone: Picks up your voice.
hdw-1_2-00.fm Page 6 Wednesday, April 24, 2002 9:24 AM

Getting started
7
■Charging the battery
The headset has a built-in rechargeable NiMH battery. If you need to
replace the battery, take the headset to your nearest qualified service
facility.
To charge the battery:
1. Connect the charger cable to the headset. For a list of compatible
chargers, see Chargers and batteries on page 5.
2. Connect the charger to an AC wall outlet. The red indicator light is
shown during charging. Charging the battery fully takes about 1 to 2
hours, depending on the charger.
3. When the battery is fully charged, the green indicator light is shown.
Disconnect the charger from the AC wall outlet and the headset.
hdw-1_2-00.fm Page 7 Wednesday, April 24, 2002 9:24 AM

Getting started
8
When the battery charge falls low
The fully charged battery has power for up to 4 hours of talk time and up
to 100 hours of standby time. (In standby mode, the headset is switched
on but no call is in progress.)
When the battery is running out of power, the headset beeps. Charge the
battery as described above.
■Adjusting the headset to your ear
You can wear the headset on either ear.
To change the orientation of the earpiece, turn the earpiece boom to back
and rotate it to the opposite side of the headset.
hdw-1_2-00.fm Page 8 Wednesday, April 24, 2002 9:24 AM

Getting started
9
■Switching the headset on or off
To switch on: Press and hold the volume down key for 2 seconds. The
headset beeps and the green indicator light starts blinking. The blinking
continues until the headset is connected to your phone, within 5 minutes.
If the headset cannot be connected to your phone during this time, the
headset is switched off.
To switch off: Press and hold the volume down key for 2 seconds. The
headset beeps and the red indicator light is shown briefly. Note that the
headset cannot be switched off during a call.
■Taking the headset into use for the first time
1. Make sure that your phone is switched on.
2. Switch on the headset.
3. Enter your phone’s Bluetooth menu and make sure that the Bluetooth
feature is activated.
4. Enter the submenu where you can set the phone to search for
Bluetooth devices, and start the search.
The phone searches for all Bluetooth devices within about 10 meters
and shows them as a list.
5. Select the headset from the list.
6. Enter the passkey to associate ("pair") and connect the headset to your
phone. The passkey is marked on the sticker that is provided in the
sales package of the headset.
hdw-1_2-00.fm Page 9 Wednesday, April 24, 2002 9:24 AM

Getting started
10
Once you have entered the passkey, your phone becomes the default
phone that uses the headset, if the headset has not been previously
paired with another phone. See also Using the headset with several
phones on page 15.
The headset beeps and appears in the phone menu where you can view
the Bluetooth devices that are currently paired with your phone.
7. Start using the headset (see page 12).
Troubleshooting
If you cannot connect the headset to your phone, proceed as follows:
•Make sure that the headset is switched on and paired with your phone.
•Make sure that the Bluetooth feature is activated on your phone.
•Check that the headset is within a maximum of 10 meters of your
phone and that there are no obstructions, such as walls, or other
electronic devices between the headset and the phone.
•The pairing information list of the headset may be full. The headset
can store the information of up to 8 phones at a time. If the list
becomes full, reset the headset to the original settings, see page 16.
•If the headset does not respond to your actions, press and hold the
volume down key for 10 seconds.
hdw-1_2-00.fm Page 10 Wednesday, April 24, 2002 9:24 AM