Nonin 8000AA User manual

* Sizing is for reference only. Fit, patient comfort and signal quality should be used to determine appropriate size/model.
quick guide
Use ONLY with compatible Nonin Medical pulse oximeter monitors.
8000AA /AP
SpO2Clip Sensors
3
3
4
Finger Symbol
* Sizing is for reference only. Fit, patient comfort and signal quality should be used to determine appropriate size/model.
1. Select the proper size sensor.*
Adult 8000AA (blue): 0.5 – 1 in (12.5 – 25.5 mm)
Pediatric 8000AP (green): 0.3 – 0.5 in
(7.5 – 12.7 mm)
2. Use clean, dry finger where sensor will be
placed. Heavy lotions, sunscreen, dirt, oils and
nail polish may alter accuracy.
3. Gently squeeze to open the sensor, and insert
the finger all the way into the sensor. The
finger symbol should be on the top of the finger.
Check that sensor gently hugs finger, and is not
too tight or too loose.
4. Secure sensor to back of hand with medical
tape to allow movement if necessary.
5. Connect to a Nonin pulse oximeter. Follow
Operator’s Manual for oximeter to measure
oxygen saturation and pulse rate.
8000AA 8000AP
=
mm
25.5
19.12
12.75
6.36
0
inch
1
.75
.5
.25
0
Actual size

Visit nonin.com for more information and video tutorials.
Nonin Medical, Inc.
13700 1st Avenue North
Plymouth, MN 55441-5443 • USA
Tel: [phone]
+1.800.356.8874
Fax: [phone]
E-mail: [email protected]
Nonin Medical B.V.
Prins Hendriklaan 26
1075 BD Amsterdam • Netherlands
Tel: +31 (0)13 - 79 99 040
Fax: [phone]
E-mail: [e-mail]
nonin.com/sensors
©2013 Nonin Medical, Inc. All trademarks are the property of Nonin Medical, Inc. unless otherwise noted.
THIS GUIDE IS FOR REFERENCE ONLY. Refer to the Instructions for Use for complete
information, warnings, cautions and specifications for the product you are using.
P/N 9476-101-01
8000AA/AP SpO2Clip Sensors
A. Use index, middle or ring finger. Rotate finger sites for extended use and comfort
as needed.
B. Do not use on arm with IV line or BP cuff.
C. Check sensor position and skin at site every 6 to 8 hours.
D. If signal quality is low on the oximeter:
1. Check sensor position and size for good fit
2. Check connection at oximeter
3. Check hand is warm, and has good blood flow
4. Use a different finger
E. Clean sensor between patients or as needed.
1. Use soft cloth with 10% bleach/90% water solution ( household bleach <
10% sodium hypochlorite )
2. Do not use ammonium chloride based cleaning fluids.
3. Open sensor up to 90 degrees to clean skin contacting surfaces. Do not
overextend. The spring on the AP model can be released for easier access.
4. Wipe away from connector plug. Do not submerge or immerse sensor or
connector plug.
5. Allow to completely dry before next use.
A short-cable model of the 8000AA Sensor is available
for use with the WristOx2
®Model 3150 Pulse Oximeter.