NORTH STATES Toddleroo 4933 User manual

Your box contains the following:
x1
Instructions for Extensions: 4938/4958
Important: Please keep for further reference.
For helpful tips and instructions, please visit our website: www.northstatesind.com
or contact our Customer Care department via email: [e-mail]
Phone [phone] or Toll Free: [phone]
•Children have died or been seriously injured when gates are not properly secured.
•ALWAYS install and use gates as directed using all required parts.
•STOP using when a child can climb over yard or dislodge the gate.
•Install only with locking/latching mechanism securely engaged.
•To prevent falls, NEVER use at top of stairs.
•NEVER use to keep child away from pool.
•This product will not necessarily prevent all accidents.
•NEVER leave child unattended.
•This product is intended for use with children from 6 months up to 24 months of age.
•Periodically check all fasteners to be sure they are tight and secure, STOP using 3-in-1
Superyard if any parts are missing or become damaged.
•When set up as a barrier, use model 4930 in openings 53.75” to 151” (136.5 cm to 383.54 cm)
and model 4929 in openings 53.75" to 199" (136.5 cm to 505.46 cm).
•Hardware is included for use in sold materials only, such as wood or metal.
•NEVER leave anything in the 3-in-1 Superyard that could provide a foothold or create a danger
of suffocation or strangulation.
•When setting up as an enclosure an unlimited number of panels may be used. When setting up
as a barrier, the maximum number of panels is twelve.
A. Two-Panel Extension
Instructions for Extensions 4931/4933/4941
For use with yard models: 4929, 4930, 4936, 4940
A
To ensure safe operation, additional or replacement parts should be obtained only from North States or its authorized
distributors. Contact information appears above. Replacement parts can be ordered at www.northstatesind.com
Any damage to property during installation of your safety gate is the sole responsibility of the end user.

Distributed exclusively in the United States by
North States Industries, Inc.
5455 Highway 169 N
Plymouth, MN 55442
www.northstatesind.com
Rev 03/2021
Manufactured in
China
Remove the vertical bar from one end on the
extension and the panel you wish to connect. Turn
clockwise to loosen and pull down to remove.
Note: If applicable, remove the Socket Cap E.
To connect the panels together, vertically lift one
panel allowing the upper and lower hinge housings
to slip into place in the mating panel.
Insert the vertical
bar into recess of
lower hinge mount.
Press “A” down and
slide it into upper
hinge.
Turn counter-
clockwise to tighten.
Step 1. Step 2.
Step 3.
Please refer to the instruction manual for additional installation information.
Page 2