Northern TVIDTW212IR User manual

TVIDTW212IR
Rev. 062015
HD-TVI, Full HD 1080p Outdoor IR Dome Camera
USER GUIDE: TVIDTW212IR
3625 Cincinnati Avenue, Rocklin, CA 95765 ♦ 888-874-3336 ♦
www.northernvideo.com
855-388-7422
.revocno-panshtiwnwohS

Precautions
Features
Dimensions
Installation
Assembly
Connection
OSD Menu Setup
Trouble Shooting
Table of Contents
02 | Dome Camera

Safety information
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK) NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
This symbol indicates that dangerous voltage consisting a risk of electric
shock is present within this unit.
This exclamation point symbol is intended to alert the user to
the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
If the product is to be put out of operation denitively,
take it to a local recycling plant for a disposal which
is not harmful to the environment.
Regulatory Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions :
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may
cause undesiredoperation.
This equipment has been tested andfoundto comply with the limits fora Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.Operation of this equipment in a residential area is likely to
cause interference, in which case the user will be required to correct theinterference
at his own expense.
Dome Camera | 03

Precautions
Handle with care. Dropping it can cause serious damage.
Do not aim camera into direct sunlight.
Use an appropriate power supply, 12VDC or 24VAC.
04 | Dome Camera
Choose an ideal location for the camera, since a camera
unit must be protected against vibration.
Be careful not to scratch the camera unit, especially
lens or dome cover.
Use the camera within the temperature (-20˚ F ~ 122˚ F)

Features
SONY 1/2.9" CMOS Sensor.
Full HD-TVI(1920x1080) Resolution.
Digital-WDR, 3D-DNR.
Day & Night Function.
Full OSD with Multi-language.
Multi function : Sense up(x2~x8), Motion Detection,
Privacy Mask, Mirror(H/V/R), D-Zoom.
25M range visible in total darkness with 24pcs of
IR LEDs.
3-Axis Bracket for 3D(Pan/Tilt/Roll) rotation.
Extra video connector for easy installation.
Coaxial communication(Pelco-C) support.
Dome Camera | 05

06 | Dome Camera
AI COVER
ROTATION
LOCK SCREW
COVER SCREW
ROTATION
LOCK SCREW
IR LED
PHOTO SENSOR
IR TYPE (AI LENS)
COVER SCREW
What's Included
Parts Identified
(1) CAMERA
(1) WHITE HOUSING
(1) VIDEO TEST CONNECTOR
(1) MOUNTING HARDWARE PACKAGE
(1) USER GUIDE
TVIDTW212IR
Rev. 062015
HD-TVI, Full HD 1080p Outdoo r IR Dome Camera
USER GUIDE: TVIDTW212IR
3625 Cincinnati Avenue, Rocklin, CA 95765 ♦ 888-874-3336 ♦
www.northernvideo.com
855-388-7422
Shown with snap-on cover.

Dimensions
MECHANICAL
Dimension
Weight
ENVIRONMENT
Construction
Ingress Protection
Operating Temp
Humidity 0% to 90%
ELECTRICAL (Power Consumption)
Power Supply Regulated 12V DC ±10%
12V DC / 24V AC Dual voltage
Current Consumption Max. 500mA (at 12V DC): LED ON
Max. 130mA (at 12V DC) LED OFF
Heater Yes
CERTIFICATION
CE, FCC, ROHS Yes
Structurespecification
Dome Camera | 07
Ø100
Ø150.5
45
95.6
Ø129
Ø150.5Ⅹ95.6(H) mm
Approx. 800g
Aluminum
IP 68
-20°F ~ 122°F

Installation
HOW TO INSTALL
08 | Dome Camera
1. Camera installation
(1)
Fix the camera set with the supplied screws on ceiling or wall mount.
If you don't use supplied screws, the camera may fall off.
(2)
Please refer to '4.Cameraangleadjustment' regarding adjust camera angle.
(3) Lens adjustment
①By turning the "Tele-Wide" knob,
you can access a range of focal
lengths within specified limits.
②Then, by turning the "Near-Far"
knob, you can set the focus toward
the desired object.
1
2w
NFT
4. Camera angle adjustment :
(1) Pan adjustment :
Grasp the disk of camera
and then adjust direction
to the right or left (-180˚~ 180˚)
(2) Tilt adjustment : Grasp the
LED cover of camera and
then adjust direction up or
down (6˚~ 90˚)
(3)
Roll adjustment : Grasp the camera holder and then rotate (-178˚~178˚)
(4) Re-assemble the camera.
ROTATION
U
D
R
L
LED COVER
DISK
CAMERA
HOLDER
<Caution>
Do not force past adjustment
range or damage may occur.
✽ For LED model, the IR LED bank is
hinged, and can be moved back to
allow access to lens adjustment. After lens adjustment is made,
be sure to move IR LED bank back to original position.

Installation
Dome Camera | 09
1. Pipe Application
(1)
Remove the screw for fixing a cable on the bottom of the base.
(2) Open the DOME COVER.
(3) Remove the TAP COVER and place the cables there.
(4) After distributing cables, use TEFLON tape on pipe threads.
(5) Combine the pipe to the base.
CABLE
PIPE
TEFLON TAPE
CABLE FIXING SCREW
DOME COVER
TAP COVER

10 | Dome Camera
Assembly/Mounting
Mounting
<Wall mount>
<Ceiling mount>
SCREW Tp1.4x25 3EA
MOUNT HOLE PLATE(STICKER)
Ø 3.5 Ø 30
Put a sticker on the ceiling and
make holes according to the
spots marked on a sticker
SCREW Tp1.4x25
3EA
MOUNT HOLE PLATE(STICKER) Ø 3.5
Ø 30
Put a sticker on the ceiling and
make holes according to the
spots marked on a sticker

Connection
AC 24V / DC 12V
VIDEO
TERMINAL
Dome Camera | 11

OSD Menu Set up
•Main Set up
EXPOSURE LENS / BRIGHTNESS / MODE / SHUTTER / AGC /
SENS-UP
WHITE BALANCE AUTO / AUTO ext / MANUAL
BACKLIGHT BLC / HLC / OFF
DAY&NIGHT AUTO_CDS/ COLOR / BW
IMAGE
DNR / SHARPNESS / COLOR GAIN / GAMMA /
D-WDR / DEFOG /
SHADING / MIRROR
SPECIAL TITLE / PRIVACY / MOTION / D-ZOOM /
LANGUAGE
RESETAll the settings will be restored to the factory default
EXITEscape the menu
•OSD Control Key
①SET : .
②UP, ③DOWN : Used to move the cursor toup or down.
④LEFT, ⑤RIGHT : Used to move the cursor to left or right and
change the value.
⑥EXT-VIDEO :
installation. Plug-in your test monitor here.
6
1
2
4
3
5
12 | Dome Camera

OSD Menu Set up
OSD Menu Control and Set up
The on-screen menu is operated with the control lever on the PCB.
To call the on-screen menu, press the control lever straight downward.
The main menu is displayed as follows.
Select the menuitem bytilting the control lever in direction ↑or ↓.
Change an adjustment bytilting the control lever in direction ←or →.
If “↵” is indicated beside menu item or an adjusting option, It is possible
to call a submenu for further adjustments by pressing down on the control
lever.
To return from a submenu to the prior menu level, select the menu item
RETURN and by pressing down the control lever. Via the submenu
item RETURN, the menu is completely exited. Exit the main menu via the
menu item EXIT.
Dome Camera | 13

Menu Set up
EXPOSURE
Function of adjusting shutter speed and AGC
LENS : Set toDC / DC auto-iris lensis standard.
BRIGHTNESS : Adjust brightness level 0(dark) ~ 20(bright)
MODE : Select AE MODE. INDOOR / OUTDOOR /DEBLUR
SHUTTER : Can be set in AUTO or MANUAL
AUTO : Auto shutter mode
MANUAL : Adjust shuttermanually. (1/30 ~ 1/60,000)
AGC : Adjust AGC level 0(low)~20(high)
SENS-UP (X2~X8, OFF) : Select maximum DSS(Digital Slow Shutter)
OFF, x2~X8 If only poor illumination is available, the light sensitivity
of the camera can be increased. The shutter time is extended so that the
exposure time covers several pictures. In the line SENSE UP it is possible
to select if the sensitivity should be increased (ON) or not (OFF). If On has
been selected, adjust the factorfor the exposure time (X2 ~ X8)
14 | Dome Camera

Menu Set up
Function of adjusting WHITE BALANCE
AUTO : Automatically adjusts color according to the lighting
AUTOext :Faster extension version of Auto
MANUAL :Manual white balance
KELVIN :LOW / MIDDLE /HIGH
R-GAIN :0~20
B-GAIN :0~20
Dome Camera | 15
White Balance

Menu Set up
BACKLIGHT
Strong/large sources of light coming from behind the main subject (such
as a person indoors that is in front of a window) cause the light meter to
underexpose for the main subject.
HLC : High Light Compensation / Masking the highlight in the image to
distinguish the subject.
BLC : Back Light Compensation / User controllable mode, shows
the subject clearly.
16 | Dome Camera

Menu Set up
DAY &NIGHT
Switching of day operation/ night operation
AUTO : Automatic switching between day operation (color mode) and night
operation (black and-white mode) depending on the ambientbrigh tness
- IR LED : IR LED ON/OFF setting
- ANTI-SAT. : CompensatewhenIRhuntinghappens.Whenyou
use this function.
- AGC THRS: Day&Night change level (AGC). Higher the value =
Longerittakes for camerato switch fromcolor toB/W.
- AGC MARGIN : Daytonight and night to day switch margin
- DELAY : DAY&NIGHT change Delay time, 0 ~ 255 second
- Cds LEVEL : Day&Nightchange level (CDS).
DAY : Color mode always on
NIGHT : Black-and-white mode always on
Dome Camera | 17

Menu Set up
DNR(3D-DNR) : Select Digital Noise Reduction (OFF / LOW /MIDDLE /
HIGH)
SHARPNESS :Adjust sharpness level (0 ~ 10)
COLOR GAIN :Adjust Color gain value (0 ~ 20)
GAMMA :Selecte gamma mode. (0.45~0.65)
D-WDR : Select Digital WDR(Wide Dynamic Range) (OFF / LOW /MIDDLE
/ HIGH)
DEFOG :Adjust DEFOG mode.
SHADING :Select Lens shading compensation. (OFF / ON)
MIRROR : Activates Image mirror
H-Flip :Flip the picture horizontally on the screen
V-Flip :Flip the picture vertically on the screen
Rotate :Flip the picture horizontally & vertically on the screen
18 | Dome Camera
IMAGE

Menu Set up
TITLE : Camera title edit and display on / o select.
PRIVACY :Hide an area you want to hide on the screen.(16 point)
MOTION : When there is movement of the subject on the screen, there
will be motion detection.
D-ZOOM :Select digital zoom magnication. Max 8x
LANGUAGE : Select Language (English, Netherlandic, Italiano, Francais,
Espanol, Deutsch)
Dome Camera | 19
SPECIAL

Menu Set up
IMAGE RANGE :Select pedestal level scale
FRAME RATE :Select HD output frame rate. 30 FPS / 25 FPS
CVBS :Select CVBS output mode. NTSC or PAL
20 | Dome Camera
SYSTEM