NUUO 7100 SERIES User manual

The Intelligent Surveillance Solution
Hardware & Software NDVR
Installation Guide
Ver. 99.350.A430.001

Intelligent Surveillance Solution
Table of Contents
page-1
T
TA AB BL LE E O OF F C CO ON NT TE EN NT TS S
TABLE OF CONTENTS ..............................................................................................1
1000 SERIES; 3000 SERIES ........................................................................................2
Product Specification ........................................................................................2
System Requirement ..........................................................................................2
Hardware Installation.........................................................................................3
6000 SERIES ..............................................................................................................7
Product Specification ........................................................................................7
System Requirement ..........................................................................................7
Hardware Installation.........................................................................................8
7000 SERIES ............................................................................................................10
Product Specification ......................................................................................10
System Requirement ........................................................................................10
Hardware Installation.......................................................................................11
7100 SERIES ............................................................................................................13
Product Specification ......................................................................................13
System Requirement ........................................................................................13
Hardware Installation.......................................................................................14
DRIVER INSTALLATION ..........................................................................................16
SOFTWARE INSTALLATION ....................................................................................18
APPENDIX - MINIMUM HARDWARE REQUIREMENT...........................................23

Intelligent Surveillance Solution
System Requirement
page-2
1
10 00 00 0 S SE ER RI IE ES S; ; 3 30 00 00 0 S SE ER RI IE ES S
Product Specification
G3 Card
System Requirement
The system requirement is depend on the number of camera connections
and the total bit rate of the IP cameras. Please refer Appendix - Minimum
Hardware Requirement or check NUUO Calculator on
http://support.nuuo.com/calculator/
3000 Series
1000 Series
Display Rate
120fps(NTSC);
100fps (PAL)
30fps(NTSC);
25fps (PAL)
Recording Rate
120fps(NTSC);
100fps (PAL)
30fps(NTSC);
25fps (PAL)
Maximum Card
2
4
Video Input
4; 8; 16
4; 8
Audio Input
4
1
Video Resolution
NTSC: 704x480 ; 640 x 480 ; 352x240
PAL: 704x576 ; 640 x 576 ;352x288
Compression Format
Software Compression MPEG 4

Intelligent Surveillance Solution
Hardware Installation
page-3
Hardware Installation
Step1: Insert the card onto an empty PCI slot. Connect the Audio/Video
Cable to the connector in the same color.
Step 2: Turn on your PC and start Windows.
Step 3: Insert the included Software CD into CD-ROM.
Step 4: Refer the section Driver Installation on page 16 to install driver.
Step 5: After driver is installed, restart your PC.
Connect the Audio/Video Cable
Note: for G3-3000 series, audio channels are located at 1, 2, 3, 4.
Optional I/O Card referring to the figures on the following pages.
Insert the card onto your PC.
Connect the Capture Card and the I/O Card with an included
ribbon cable. You may connect the ribbon cable to one of the
I/O ports on the Capture Card.

Intelligent Surveillance Solution
Hardware Installation
page-4
G3-3000 Series Capture Card
I/O Card
Relay Out 1-4
Alarm Input 1-4
RS-485+
RS-485-
RS-Ground
1-4
Ground
RS-232 to RS-485
RS-485+
RS-485-
RS-Ground
1-4
RS-485

Intelligent Surveillance Solution
Hardware Installation
page-5
G3-1000 Series Capture Card
I/O Card
Relay Out 1-4
Alarm Input 1-4
RS-485+
RS-485-
RS-Ground
1-4
Ground
RS-232 to RS-485
RS-485+
RS-485-
RS-Ground
1-4
RS-485

Intelligent Surveillance Solution
Hardware Installation
page-6
G3-card Watchdog Installation

Intelligent Surveillance Solution
Product Specification
page-7
6
60 00 00 0 S SE ER RI IE ES S
Product Specification
System Requirement
The system requirement is depend on the number of camera connections
and the total bit rate of the IP cameras. Please refer Appendix - Minimum
Hardware Requirement or check NUUO Calculator on
http://support.nuuo.com/calculator/
6016
6008
6004
Display Rate
480fps(NTSC);
400fps (PAL)
240fps(NTSC);
200fps (PAL)
120fps(NTSC);
100fps (PAL)
Recording Rate
(CIF)
480fps(NTSC);
400fps (PAL)
240fps(NTSC);
200fps (PAL)
120fps(NTSC);
100fps (PAL)
Maximum Card
2
4
4
Video Input
16
8
4
Audio Input
16
8
4
Video Resolution
NTSC: 176x120; 352x240; 704x480
PAL: 176x144; 352x288; 704x576
Compression Format
Hardware Compression H.264

Intelligent Surveillance Solution
Hardware Installation
page-8
Hardware Installation
Connecting the Audio/Video Cable - referring to the figure on next page.
The audio input connectors are with yellow wires and marks of “A”
on them (such as “A1/9”); the video input connectors are with black
wires and the marks of “V” (such as “V8/16”).
Connecting the Watchdog Wire - referring to the figure on next page.
Plug the Watchdog Wire to the Reset connector of the Hardware
Compression Card and then connect it to the Reset connector on
the main board.
With the Watchdog Wire connected, the system will be restarted if
any abnormal conditions.

Intelligent Surveillance Solution
Product Specification
page-9
6000 Series Capture Card

Intelligent Surveillance Solution
Product Specification
page-10
7
70 00 00 0 S SE ER RI IE ES S
Product Specification
System Requirement
The system requirement is depend on the number of camera connections
and the total bit rate of the IP cameras. Please refer Appendix - Minimum
Hardware Requirement or check NUUO Calculator on
http://support.nuuo.com/calculator/
7016
7008
7004
Display Rate
480fps(NTSC);
400fps (PAL)
240fps(NTSC);
200fps (PAL)
120fps(NTSC);
100fps (PAL)
Recording Rate (D1)
480fps(NTSC);
400fps (PAL)
240fps(NTSC);
200fps (PAL)
120fps(NTSC);
100fps (PAL)
Maximum Card
2
4
4
Video Input
16
8
4
Audio Input
16
8
4
Video Resolution
NTSC: 176x120; 352x240; 704x480
PAL: 176x144; 352x288; 704x576
Compression Format
Hardware Compression H.264

Intelligent Surveillance Solution
Product Specification
page-11
Hardware Installation
Connecting the Audio/Video Cable - referring to the figure on next page.
The audio input connectors are with yellow wires and marks of “A”
on them (such as “A1/9”); the video input connectors are with black
wires and the marks of “V”(such as “V8/16”).
Connecting the Watchdog Wire - referring to the figure on next page.
Plug the Watchdog Wire to the Reset connector of the Hardware
Compression Card and then connect it to the Reset connector on
the main board.
With the Watchdog Wire connected, the system will be restarted if
any abnormal conditions.

Intelligent Surveillance Solution
Product Specification
page-12
7000 Series Capture Card

Intelligent Surveillance Solution
Product Specification
page-13
7
71 10 00 0 S SE ER RI IE ES S
Product Specification
7116
7108
Display Rate
480fps(NTSC); 400fps
(PAL)
240fps(NTSC); 200fps
(PAL)
Recording Rate (D1)
480fps(NTSC); 400fps
(PAL)
240fps(NTSC); 200fps
(PAL)
Maximum Card
1
1
Video Input
16
8
Audio Input
16
8
Video Resolution
NTSC: 176x120; 352x240; 704x480
PAL: 176x144; 352x288; 704x576
TV Output Rate
w/ HDMI: RCA & HDMI: 10fps
w/o HDMI: RCA: 25fps
Only HDMI: HDMI: 14fps
Compression Format
Hardware Compression H.264
System Requirement
The system requirement is depend on the number of camera connections
and the total bit rate of the IP cameras. Please refer Appendix - Minimum
Hardware Requirement or check NUUO Calculator on
http://support.nuuo.com/calculator/

Intelligent Surveillance Solution
Product Specification
page-14
Hardware Installation
Connecting the Audio/Video Cable - referring to the figure on next page.
The audio input connectors are with yellow wires and marks of “A”
on them (such as “A1/9”); the video input connectors are with black
wires and the marks of “V” (such as “V8/16”).
Connecting the Watchdog Wire - referring to the figure on next page.
Plug the Watchdog Wire to the Reset connector of the Hardware
Compression Card and then connect it to the Reset connector on
the main board.
With the Watchdog Wire connected, the system will be restarted if
any abnormal conditions.
Note 1: Before installing SCB-7100 Series cards, please connecting HDMI
cable first then it would be easier to fix the card onto the PCI-e slot.
Note 2: Some chassis may not be suitable for installing SCB-7100 series due
to the original design, please check the dimension of the chassis before
installing.

Intelligent Surveillance Solution
Hardware Installation
page-15
7100 Series Capture Card

Intelligent Surveillance Solution
Driver Installation
page-16
D
DR RI IV VE ER R I IN NS ST TA AL LL LA AT TI IO ON N
Step 1: Insert the Installation CD. Run autostartup.exe from the
CD-ROM directly to start the installation.
Step 2: Select “DVR Driver Installation” then click on it.
Step 3: In the NUUODriver Setup Wizard dialog box, click Next to
continuous.
Step 4: Check the “License agreement”. Click “I Agree” to continuous.

Intelligent Surveillance Solution
Driver Installation
page-17
Step 5: Installing NUUODriver.
Step 6: Click “Finish” after installing the system completely, and then
choose to reboot now or later.

Intelligent Surveillance Solution
Software Installation
page-18
S
SO OF FT TW WA AR RE E I IN NS ST TA AL LL LA AT TI IO ON N
Step 1: Insert the Installation CD. Run Autorun Tool from the CD-ROM
directly to start the installation.
Step 2: Select “Server Application Installation” then click on it.
Step 3: There are 4 system types of options in “System Setup Tool” window,
select one and click Next to start the installshield of Server
package.
-NUUO IP Surveillance System/Trial System
-NUUO MPEG-4 Hybrid System
-NUUO H.264 Hybrid System
-NUUO Full D1H.264 Hybrid System
Note: The SetupTool will detect the type of capture cards installs
on PC and enable the options of system types automatically.

Intelligent Surveillance Solution
Software Installation
page-19
Step 4: In the InstallShield Wizard dialog box, click Next to continuous.
Step 5: Check the option “I accept the terms of the license agreement”.
Click Next to continuous.
Step 6: Please enter your name and the company name for which you
work. Click Next to continuous.