Nyos TORQ User manual

(Fig 1)
Removal position
Setting the flow rate
(Fig. 5)
NYOS®TORQ®QUICK START
Step 01 Positioning the TORQ®Dock in the sump
• In sump use only
• Avoid contact to side panes
• Only plug in, when the body is on the
dock
Full instructions and safety information Video instructions and tips
Step 03 Insert TORQ®Body and start operation
1. Fit the body on the dock in the removal position
(Fig. 5)
2. Plug in the dock
3. It is possible to change the flow rate by rotating
the body.
4. Set the flow rate so that the filter media will be
hold in suspense
NOTE: A smear layer will form after a few days.
This will result in a quieter return flow and bubble
formation will reduce.
Manufactured by
Nyos®Aquatics GmbH,
Siemensstr. 26,
70825 Korntal-Muenchingen, Germany
www.nyos.info, [e-mail]
EN

3.2.
1.
4.
(Fig. 4)
(Fig. 2)
3.
1.
(Fig. 3)
Filling with two filter media (only TORQ®Body 1.0
and Body 2.0)
1. Turn body upside down and remove screen
insert and separating screen
2. Add filter media to the top chamber
3. Insert filter sponge without hole and and sepa-
rating screen. Add second filter media, hold the
acrylic stick firmly while doing so.
4. Close the body by fitting the screen insert
General Information
• The groove in the acrylic tube and the lug
on the screen insert must sit on top of each
other during assembly (Fig. 2)
Step 02 Filling the TORQ®Body
Filling with one filter media
1. Remove lid
2. Only body 1.0 and 2.0: Remove separating
screen
3. Add filter media and put the lid back on