Ohlins HD 907 User manual

Shock Absorber for Harley Davidson XR1200
HD 907
Mounting Instructions
Part No. Pcs.
Shock Absorber HD907 1
Sleeve 00123-13 4
Washer 03118-08 8
Tool preload adj. 03199-01 1
Sticker set Öhlins 1
Owner’s Manual 07241-02 1
Before installing this product, check the
contents of the kit. If anything is missing, please
contact your nearest Öhlins dealer.
Kit Contents
Please note that during storage and
transportation, especially at high ambient
temperature, some of the oil and grease used for
assembling may leak and stain the packaging.
This is in no way detrimental to the product,
wipe off the excessive oil/grease with a cloth.
Warning!
Before installing this product, read the Öhlins
Owner’s Manual. The shock absorber is an
important part of your vehicle and will affect the
stability.
03118-08
00123-13
03118-08
00123-13

1
How to install
Warning!
It is advisable to have an Öhlins dealer install the
shock absorber.
When installing, consult your Vehicle Service
Manual.
1
Put the motorcycle on a workstand so that
the rear wheel barely touches the ground.
Warning!
Make sure the vehicle is securely supported so
that it will not tip.
2
Remove the original shock absorbers. Consult
your Vehicle Service Manual.
Note!
Before installing the Öhlins shock absorber clean
the vehicle thoroughly.
3
Install the Öhlins shock absorbers in the
same way as the original units. The shock
absorber should be installed with the cylinder
head at the top and the reservoir towards the
rear. Use the washers and sleeves provided
in this kit.
Note!
Lower the motorcycle so that the shock
absorber is sligthly compressed, before
tightening the screws.
Caution!
Make sure that all screws are tightened to the
correct torque and that nothing fouls or restricts
movement of the shock absorber when the
suspension is fully compressed or extended.
03118-08
00123-13
03118-08
00123-13

2
Adjustments
Warning!
Before riding, always make sure that the
basic settings made by Öhlins are according
to recommended Set-up Data. Read about
adjustments and setting up in the Öhlins Owner’s
Manual before you make any adjustments.
Contact an Öhlins dealer if you have any
questions about setting up the shock absorber.
Caution!
The drive belt tension shall only be adjusted
when the original shock absorber is installed on
the vehicle.
03118-08
00123-13
03118-08
00123-13
Recommended set-up
Spring Preload 23 mm
Shock Absorber Length 360 +10/0mm
Stroke 97
Free spring length 230 mm
Free Sag (R1-R2) 8 mm
Ride Height (R1-R3) 37 mm
Read about Free Sag and Ride height in the
Öhlins Owner’s Manual.
Set-up Data
Length Adjuster
!
Spring Preload
Adjuster

Öhlins Racing AB
Box 722
S-194 27 Upplands Väsby, Sweden
Phone [phone]
fax [phone]
© Öhlins Racing AB. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
www.ohlins.com
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updates
may occur.
To find the latest information contact
your Öhlins distributor. Please
consult your Öhlins dealer if you
have any questions regarding the
contents in this document.
Part no. HD907_1
Issued 2017-01-01