3
ENGLISH
Unpacking and Setting Up the Cash Register
NOTE: Please read this section carefully before attempting to program
the cash register or perform sales transactions.
As soon as you receive the cash register, open its shipping carton and
carefully withdraw each component. Make sure that the cash register
and all of its accessories, listed in the section entitled Standard
Accessories, are present in order to setup the cash register by following
these guidelines:
1. Place the cash register on a level, stable, vibration-free and dust-
free surface. Make sure it is near a grounded power outlet.
2. Install the inked ribbon cartridge as explained in the section
Installing the Ribbon Cartridge.
3. Plug the cash register to a grounded power outlet and press the
Reset button located inside the printer compartment, on the rear
left-hand side, to reinitialize the cash register's memory. To remove
and replace the printer compartment cover, refer to the steps 1 and 6
in the section Installing the Ribbon Cartridge.
It is suggested that you plug the cash register to a grounded power
outlet on its own so as to avoid potential electrical interference with
any other electrical equipment which may be plugged to the same
outlet.
4. Load the paper tape as explained in the section Loading the
Customer Receipt and Journal Paper Rolls.
5. Proceed to set the desired program options as explained in the
section Cash Register Programming. Keep the cash register
plugged to the electrical outlet for at least 48 hours so as to
charge the memory back-up battery inside the cash register.
6. Once the desired program options have been set, turn the control
key to the REG 1 or REG 2 position and you are ready to perform
sales transactions. In the REG 2 position the cash register will not
print the customer receipt.
Maintaining the Cash Register
Provided below is information on how to maintain your cash register.
NOTE: Before cleaning the cash register, make sure it is powered off
and/or unplugged from the wall outlet. Machine programming
data and transaction information for management reports are
stored in the cash register. A back-up battery inside the cash
register saves this information when the cash register is
unplugged from the power outlet or the event of a power
failure.
1. Keep all liquids away from the cash register so as to avoid spills
which could damage the electronic components.
2. To clean the cash register firstly turn it off and/or unplug it from the
wall outlet, then use just a damp cloth. Do not use corrosive
substances such as solvents, alcohol, petrol, or abrasive compo-
nents.
3. If the cash register is stored in extreme hot or cold temperatures
(below 32 degrees or above 104 degrees Fahrenheit), allow the
temperature inside the cash register to reach room temperature
before turning it on.
4. DO NOT attempt to pull the paper tape when the cash register is
printing or when you are loading paper. Always use the [R feed]
key to feed paper. Pulling the paper tape could damage the print
mechanism.
