Olympus HysteroFlow User manual

HYSTEROFLOW / HYSTEROBALANCE II
HYSTEROSCOPIC FLUID MANAGEMENT SYSTEM
QUICK EFE ENCE GUIDE
Option 1: Technical Assistance
Option 2: Cust mer Service
Option 3: Repair
Option 4: Field Invent ry
All manuals and user guides at all-guides.com
all-guides.com

2HYSTEROF OW QUICK REFERENCE GUIDE
WARNING
This quick reference guide is only a summary
of the HysteroFlow/HysteroBalance II
Instructions for Use. For detailed operating instructions,
be sure to follow the Instruction Manual that was
included with your device when purchased.
All manuals and user guides at all-guides.com

HYSTEROF OW QUICK REFERENCE GUIDE 3
CONNECT INFLOW TUBING
1. Turn the unit on.
2. After self test, press Menu to check
or change system settings. (Refer
to page 4 for menu settings)
3. Hang fluid irrigation bags on the
upper scale hooks.
4. Close inflow and outflow stopcocks
on the instrument.
5. Connect blue eur ok on the inflow
tubing to the inflow port on the
instrument.
6. Press OK next to Operative Mode
and press Start.
7. Carefully insert the pressure chamber
on the inflow tubing into the lower
retainer on the pump, and wrap the
tubing up and around the roller wheel,
locking it into place.
8. Clamp tubing and spike fluid irrigation
bag(s). Open one clamp.
All manuals and user guides at all-guides.com

4HYSTEROF OW QUICK REFERENCE GUIDE
MENU SETTINGS
After each menu selection, press OK.
Nominal Flow Menu
Select a nominal flow value between
30 and 500 ml/min.
Maximum Deficit Menu
Select a deficit threshold value between
200 and 2500 ml.
Alarm Volume Menu
Select a volume between 1 and 5.
Bag Size
Select a bag size between 0 and 5 liters.
General Settings Menu
To view and change anguage, Sensor Test,
Factory Defaults, Demo Mode, Brightness.
All manuals and user guides at all-guides.com

HYSTEROF OW QUICK REFERENCE GUIDE 5
CONNECT OUTFLOW TUBING
INSTRUMENT RECOGNITION (IR)
1. Open the inflow stopcock on the
instrument.
2. Close the outflow stopcock on the
instrument.
3. Hold the instrument at operative height.
4. When prompted, press Yes to begin
IR activation.
5. Turn the inflow stopcock off when
IR is complete. Screen prompt and
single beep indicate IR completion.
Do Not Press Stop!
1. Place containers on the bottom scale
and toggle them with the connection
tubes.
2. Connect the yellow eur ok on the
outflow tubing to the outflow port of
the instrument.
3. Connect the short end of the Y tube
to the patient drape.
4. Connect the long end of the Y tube
to the “Patient” port of the first
container.
5. Connect the last container tubing
to suction.
To Suction
Outflow
All manuals and user guides at all-guides.com