ONV POE31004P User manual

USER GUIDE
10 /100M Ethernet PoE Switch
Po E & O pt ical Tra n s m iss i o n
Statement
Copyright @ 2002-2013 Optical Network Video Technologies (Shenzhen) Co., Ltd
All Rights Reserved
®
!
Packing List
Please kindly check the following items:
1 PoE switch
1 Power Adapter
2 Mounting Kits
1 User Guide/Conformity Certificate/Warranty Card
Note
If any shortage or damage found, please contact us in time.
This document contains proprietary information that is protected by copyright. No part of this document may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language, in any form or by
any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise without the prior written
permission of Optical Network Video Technologies (Shenzhen) Co., Ltd.
is the registered trademark of Optical Network Video Technologies (Shenzhen) Co., Ltd. The information
and product specifications within this document are subject to change at any time, without notice and without obli-
gation to notify any person of such change.
Product overview
Product Introduction
10/100M unmanaged PoE switch can provide both 10/100M Ethernet data and Power over network cable, it
can be used as Ethernet Power Sourcing Equipment, it can automatically detect and identify whether connected
devices such as IP camera comply with standard IEEE PoE 802.3af, 802.3at and supply power for them. 10/100M
unmanaged PoE switch easier the deployment of Wireless AP, IP camera and IP-based network equipment.
PoE Techno log y is Po wer o ver Ethernet technology, It is refering t o tra nsf er bo th Ethenet dat a and a nd DC P owe r at th e same time for IP P hon e,
Wilress AP , IP- bas ed ca mer a. These devic es wh ich r ece ive DC power is ca lle d Pow ere d Device(PD) .
Note
The product ‘Switch’ mentioned in the manual, if without a special request, it is refering to 10/100M unman-
aged PoE switch, PoE switch in short in below.
Feature
Comply to IEEE802.3, IEEE802.3u, IEEE802.3af, IEEE802.3at.
10/100M self-adaptive, down link port support PoE.
All the ports support Auto MDI/MDIX.
Each PoE port support Power up to 15.4Watts(IEEE802.3af), 30Watts(IEEE802.3at)
Comptible with Powered device applied to IEEE802.3af
Support IEEE802.3x Full Duplex flow control and Duplex backpressure flow control fuction
Automatic MAC address learning and aging.
1K MAC Address
1.6G Broadband and 96Kb forwarding memory.
High perfermance full load power configuration.
LED indicator monitor working status and help fault detection
!
Technical Structure and Port Description
189mm
Link POE
POE Sw itch
1234
102mm
AB
PWR
5678
UPLINK
12345678
PWR UPLINK
28mm
POWE R
C
189mm
Link POE
POE Swi tch
1234
102mm
AB
A. 8 Po E Ports B U p-lin k Fiber P ort C. Po wer Sup ply: DC 4 8V Inpu t
PWR
5678
FIBER
12345678
28mm
PWR FIBER
POWER
C
118mm
Link P OE PWR
POE Sw itch
1234
25mm
89mm
UP LINK
1234
POWE R
AB
C
A. 4 Po E Ports B . Up-li nk RJ45 P ort C. Po wer Sup ply: DC 4 8V
UPLINK
118mm
Link P OE PWR
POE Sw itch
1234
25mm
89mm
1234
POWE R
AB
C
A. 4 Po E Ports B . Up-li nk Fibe r Port C. P ower Su pply: D C 48V Inp ut
FIBER
FIBER
4 Port 10/100M PoE Switch
A. 8 Po E Ports B . Up-li nk RJ45 P ort C. Po wer Sup ply: AC 100~2 45V, 50 Hz
AC 220 V 50Hz
B
c
279mm
44mm
195m m
10/100M PoE Switc h
Power Over Ethernat PoE Switch
Link POE
1234
PWR
5678
UPLINK
12345678
PWR UPLINK
A
4 Port 10/100M PoE Fiber Switch
8 Port 10/100M PoE Switch 8 Port 10/100M PoE Fiber Switch 8 Port 10/100M PoE Switch with
Built-in Power Supply
A. 4 Po E Ports B . Up-li nk RJ45 P ort C. Po wer Sup ply: AC 1 00~24 5V, 50H z
AC 220 V 50Hz
B
c
184mm
38mm
114mm
10/100M PoE Switch
Power Over Ethernat PoE Switch
Link POE
1234
UPLINK
1234
UPLINK
A
4 Port 10/100M PoE Switch with
Built-in Power Supply
A. 8 PoE P orts B. Up -link R J45 Por t C. Power S upply : DC 48V In put

Indicator description:
Indicator Status Description
Power indicator: P ON Working
OFF Power off
PoE indicator: PoE
(Green LED)
ON Connected PD device, working properly
Short circuit or Current overload
No connected PD device or No power supply
Fiber port working properly
Fiber link were connected properly
Not connected
Data transmission properly
Connected 10M or 100M device
Not connected device
Please confirm that the PD devices are complying with IEEE802.3af/at standard.
Priority: this function will protect device when it is overload, if all PD consumption are higher than specified,
switch port will be sorted by priority, port1, port2, port3, port N then power supply of lowest priority will be off.
Power port, Power adapter: please use 48V power supply, the switch will be damaged if use mismatched power
supply; Please input AC110-245V\50Hz for internal power supply switch.
PoE port: The PoE ports include PoE function, it can transmit power and data when connected matching device,
you can estimate the working status of each port on front panel LED.
Ethernet Port: Except PoE port, other port are Ethernet RJ45 port, all port support Auto MDIMDIX, plug and play,
also you can estimate the working status of each port on front panel LED.
Blink
OFF
Fiber indicator: F
Blink
ON
OFF
Link indicator Link
(Yellow LED)
Blink
ON
OFF
!Note
AC Adapter
PoE Switch
PoE 3 10 04P
UPLINK
DC OUT
NVR
PoE Splitter
PD 3101
IP Cam era
Cat.5 netwo rk cabl e
(POE transmi ssion )
Monito r
PoE IP Ca mera PoE IP Came ra
PoE Camera
IP
Cat. 5Video l ine
Cat. 5
netw or k
cable
PD-Powered Device
Power over Ethernet Splitter
OFF:12V
ON:5V
PoE RUN
PoE IN
DC OUT
DC RUN
Ethernet out
IN
OUT
Connection Diagram
!
Installation guide
Please install with the supporting devices.
Installation
Please confirm the following things before installation:
1 If the POE port power meet the power requirement of the connecting devices.
2 If the POE standard requirement and power supply match with the power receiving device,
“1/2+、3/6-(End-span)/4/5+、7/8-(Mid-span).
3 If the output power of the supporting power adapter is consistent with the specification in the label of the POE switch.
Please install the POE switch according to the following steps:
1 Put the POE switch on the surface of a large and stable table.
2 Plug the power adapter into the power connector, and then connect the power outlet through the power cord.
3 Connect the network devices to the POE switch port though network cable.
Please do not put heavy products on the POE switch, and please ensure good ventilation environment for the POE
switch.Please cut off the power first before plugging the power adapter.
Power
Connect the power cord, plug it in, turn on the power. When turned on, the switch will automatically initialize, and
at this time the following cases will occur for the LED lights:
1 Except the POE port lights, all the other lights will be off after bright, which means the restoration is successful.
2 Power LED remains lit.
If initialization is inconsistent with the above, please check the power.
Note
!Note
Model description with details
POE31004P:5 port 1 0/10 0M POE s witch， 1-4 port support PO E， IEEE 802. 3af, s ingle port power 15 .4W, POE po wer bu dget 65W
ONV-
transmission ran ge 100 M(bu ilt-in power supp ly ver sion c an be or dered)
ONV-POE31004P-a t:5 po rt 10/ 100M POE switch,1-4 por t supp ort PO E IEEE 802.3at single po rt pow er 30W ,POE p ower budget 110W
transmission ran ge 100 M(bu ilt-in power supp ly ver sion c an be or dered)
ONV-POE31004PF: 5 port P OE swi tch, 1-4 port support PO E,IE EE80 2.3a f,single port pow er 15. 4W,P OE pow er budget 65W, Ethe rnet t rans miss ion
range 100M,u plin k port i s sing le mode dual fiber SC i nter face (20k m),(built-in po wer su pply v ersion can be order ed)
ONV-POE31004PF- at:5 p ort PO E swit ch,1-4 port suppo rt POE ,IEE E802 .3at,single por t powe r 30W, POE po wer budget 110W, Et hern et
transmission ran ge 100 M,up link port is single m ode du al fib er SC in terface(20km) ,(bu ilt- in power supply version c an be or dere d
ONV-POE31004P-N :5 por t 10/1 00M POE switch， 1-4 port sup port P OE， IEE E802 .3af, single port p ower 1 5.4W ,POE p ower budget 65W
transmission ran ge 100 M
ONV-POE31008P:9 p ort 10 /100 M POE switch,1-8 port sup port P OE,I EEE8 02.3af,single p ort po wer 15 .4W,POE power budget 13 0W,t rans mission
range 100M(b uilt -in po wer su pply version can be o rder ed)
ONV-POE31804P: 9 po rt 10/ 100M P OE swi tch ,1-4 port suppo rt POE ,IEE E802 .3af,single por t powe r 15.4 W,PO E power budget 65W,
transmission ran ge 100 M(bu ilt-in power supp ly ver sion c an be or dered)
ONV-POE31008PF: 9 p ort 10 /100 M POE sw itch,1-8 port sup port P OE,I EEE8 02.3af,single p ort po wer 15 .4W, POE power budget 13 0W,E ther net
transmission ran ge 100 M,up link port is single m ode du al fib er SC in terface(20km) ,(bu ilt- in power supply version c an be or dere d)
ONV-POE31804PF: 9 p ort 10 /100 M POE sw itch,1-4 port sup port P OE,I EEE8 02.3af,single p ort po wer 15 .4W, POE power budget 65 W,Et hern et
transmission ran ge 100 M,up link port is single m ode du al fib er SC in terface(20km) (bui lt-i n power supply version ca n be ord ered )
ONV-POE31804PF- at: 9 po rt 10/ 100M POE switch,1-4 por t supp ort PO E,IE EE802.3at,sin gle po rt pow er 30W,POE power budget 1 30W, Ethe rnet
transmission ran ge 100 M,up link port is single m ode du al fib er SC in terface(20km) (bui lt-i n power supply version ca n be ord ered )
ONV-POE31008PN- at:9 p ort 10 /100M POE switch,1-8 po rt sup port P OE,I EEE802.3at,si ngle p ort po wer 30W,POE power budge t 250W ,
transmission ran ge 100 M,bu ilt-in power supp ly.
ONV-POE31008PF- at:9 p ort 10 /100M POE switch,1-8 po rt sup port P OE,I EEE802.3at,si ngle p ort po wer 30 W,POE power budge t 250W ,
transmission ran ge 100 M,up link port is single m ode du al fib er SC in terface(20km) ,bui lt-i n power supply.
ONV-POE31008PS: 9 port 1 0/10 0M POE switch,1-8 port su ppor t POE, IEEE 802.3af,singl e port p ower 1 5.4W,POE power budget 1 10W, tran smis sion
range 100M(b uilt -in po wer su pply version can be o rder ed)
ONV-POE31804P-a t: 9 por t 10/1 00M POE switch ,1-4 port su ppor t POE, IEEE 802.3at,singl e port p ower 3 0W,P OE power budget 130 W,
transmission ran ge 100 M(bu ilt-in power supp ly ver sion c an be or dered)
ONV-POE31008PN: 9 port 1 0/10 0M POE switch,1-8 port su ppor t POE, IEEE 802.3af,singl e port p ower 1 5.4W,POE power budget 1 30W,
transmission ran ge 100 M,bu ilt-in power supp ly.
www.onvcom.com