
OPERATING INSTRUCTIONS
1. Charge the battery
Connect the camera to a computer or USB
wall charger for charging. The Charging Indicator
light will flash red to indicate charging in
progress. The light will stop flashing when
charging is complete. Ensure that the battery
is fully charged before use.
2. Using the Micro SD card
Push the Micro SD card into the slot until it
clicks into place. The label will face the front of
the camera. To remove the Micro SD card, press
the tail of the storage card inward softly and it
will eject from the camera.
Note: Please use Class
10 Micro SD cards up to
64GB only. Please turn
off the camera prior to
plugging-in or pulling-out
the memory card.
3. Power On/Off
Power On: Press and hold the Power/Mode
button for 3 seconds, the screen will turn
on and the camera will be ready for use.
Power Off: Hold the Power/Mode button
for 3 seconds, when the camera is in the idle
state, to turn it off.
4. Cycling between modes
The camera has 5 modes: video recording,
photography, slow motion, playback and
settings. After the power is on, press the
Power/Mode button to cycle between them.
5. Busy Indicator light
The Busy Indicator light will flicker blue when
the camera is recording videos, shooting
photos and etc. When not busy the indicator
light will be solid blue with no flicker.
1080P60FPS 14.7GB SD
16M 17686 SD
720P120FPS 14.7GB SD
Video
Recording
Mode
Photography
Mode
Slow
Motion
Mode