Oregon Scientific PE316FM User manual

5. Press MODE again, the “second digits” will flash. Use the ( )
buttontosetthe“seconddigits”tozero.Alternatively,waituntilthe
second digits correspond to the correct time and then press MODE
to confirm and exit.
HOW TO USE THE PEDOMETER
Amainfeatureoftheunit,thepedometerfunctionwillcountthenumber
of steps a person takes.
1. Press MODE to toggle between STEP and DIST/TIMER display
modes..
2. Set the unit in STEP mode.
3. Press RESET, the pedometer display will return to zero. [FIG. D]
Note on motion sensitivity:
Tomaketheunitmoreorlesssensitivetomotion,repositionthemotion
sensitivity slide switch. To determine the proper amount of motion
sensitivityfor an individuals walking pattern,experimentwith different
settings.
HOW TO SET THE DISTANCE FUNCTION
This unit can measure the total distance walked or ran. Press MODE to
toggle between STEP and DIST/TIMER display modes. Set the unit in
DIST/TIMERmode.[FIG.E]The toplineofthedisplay showsthe total
distance a person has walked or ran.
The distance display will automatically reset to zero when the total
number of steps taken (in the STEP display mode) is reset.
MEASURING DISTANCE CORRECTLY
Measuring distance correctly depends on setting the correct average
lengthofanindividualstride.The stridecan beset between30 to150 cm
(or 11 to 60 inches for imperial version).
To enter the length of a stride:
1. Press MODE to toggle between STEP and DIST/TIMER display
modes.
2. Enter DIST/TIMER mode.
3. Pressandhold MODE for two seconds.Theunit will enterSTRIDE
mode display. [FIG. F]
4. Press ( ) until the desired stride length is entered.
5. Press MODE to exit.
Note: if no changes are made to the Stride function, the unit will
automaticallyreturnto theDIST/TIMER displaymodesinfiveseconds.
Anindividuals stride may varyinlength. Input the appropriatelengthfor an
individualsaveragewalkinglength.Todetermineyouraveragestridelength,
walk10 steps and divide by10thetotal distance covered. Set theunittothis
number.
HOW TO SET THE TIMER FUNCTION
The count-up timer will start from zero and count to a maximum time of 99
hours, 59 minutes, and 59 seconds (99:59’59’’).
1. In DIST/TIMER mode, to start the timer, press ST/SP.
2. To stop the timer, press ST/SP again.
3. To reset the timer to zero, press RESET.
HOW TO OPERATE THE RADIO
The radio will automatically turn on when the ear phones are inserted into
the ear phone jack. The ear phone icon [ ] will display. The icon will not
be affected by the display mode. To deactivate the radio, gently pull the ear
phones from the ear phone jack. The ear phone icon will disappear.
To find the radio station of your choice:
1. PressSCAN.Theunitwillscanupwardthroughhigherfrequenciesuntil
theappropriateradioreceptionisestablished.Thescanfunctionwillthen
automatically stop.
2. Press SCAN again. The scan function will move to the next highest
reception. When the unit reaches 108 MHz, the scan function will stop.
3. Toggle with the VOLUME CONTROL to increase or decrease the
volume to your desired level
4. PressRADIO SCAN RESET to return tothelowend of the frequency.
Notes to remember when using the FM radio:
1.When the radio is not in use, removetheearphonefrom the earphone jack,
otherwise the batteries will drain.
2.Prolonged simultaneous use of theELbacklight and the FM radiomay
causebatteries to deplete rapidlyand affect the quality of reception.
SPECIFICATIONS
Operating Modes : STEP, DIST/TIMER, STRIDE
Real timeclock : 12 hour / 24 hour option with hour/minute/
seconddisplay
Step counter : 0 to 99,999 steps
Distance traveled : 0 to 999.99 km (or 0 to 999.99 miles for
imperialversion)
Count up timer : 99 hours, 59 minutes, 59 seconds
Stride distance : 30 to 150 cm (or 11 to 60 inches for imperial
version)
Auto scan FM radio : FM 88-108 MHz
Operation temperature : -10°C to 40°C
Storage temperature : -20°C to 60°C
Power source : 2 x LR44 1.5V batteries or equivalent.
PEDOMETER WITH FM RADIO
INSTRUCTIONMANUAL
INTRODUCTION
Congratulations on your purchase of the easy-to-use multifunction light
weight pedometer with FM radio.
This product has several functions that are useful to an individual who is
activeorfrequentlyiswalkingorrunning.Apedometer,thisunitcanmonitor
thenumberofstepsthatittakestogofromonelocationtoanother.Bysetting
the stride distance, the unit will determine the distance walked. Also, with
the count-up timer, the total amount of time that it takes to cover a given
distance is monitored.
Other features, ideal for regular exercise routines or commuting, are the
clock and FM radio.
FEATURES
1. Step counter
2. 12 /24 hr. real time clock
3. Total distance monitor
4. Stride length adjustment
5. Count-up timer (99 hour, 59 minute, 59 seconds)
6. Auto scan FM radio (88 - 108 MHz)
7. Low battery indicator [ ]
8. EL backlight
9. Motion sensitivity adjustment
NAMES AND FUNCTIONS [FIG. A]
A. LCD
Two line display with three different display modes
B. RESET Button
Resets display mode values to zero
C. MODE Button
Alternates between different display modes
D. ST/SP Button
To start or stop the timer
E. Backlight ( ) and ( ) Button
Turn backlight on, increases value in display settings
F. Motion Sensitivity Slide Switch
Increases or decreases the unit’s response to motion
G. Ear Phone Speaker
Small ear mount speakers for listening to the radio
H. Ear Phone Jack
Insert the ear phone speaker to turn on the radio and listen
I. Radio Reset Button
J. Radio Scan Button
Scans radio frequency for radio reception
K. Volume Control
Controls radio volume
L. BatteryCompartment
Insert two (2 pieces) LR44 size batteries
M. Cover Release Button
Press to open protective cover
N. Cover
Protects LCD panel
O. Belt Clip
Clips to belt or clothing
OPENING THE COVER
Holding the pedometer upright, grasp the clip with one hand and press the
COVER RELEASE button with the other.
BATTERY INSTALLATION: MAIN UNIT
1. Gently press and pull the battery compartment door.
2. Insert two (2 pieces) LR44 size 1.5V batteries or equivalent. [FIG. B]
3. Replace the battery compartment door.
Note:If not disposed of properly, batteriescanbeharmful. Protect the
environmentbytakingexhaustedbatteriestoauthorizeddisposalstations.
HOW TO WEAR THE PEDOMETER
Attach at waist level to your belt, slacks, or training attire. Maintaining a
horizontal position, attach securely. [FIG. C]
Note: Improper positioning of the pedometer may result in incorrect data
collection.
HOW TO SET THE TIME
1. Press MODE to toggle between STEP and DIST/TIMER display
modes.
2. In STEP mode, press and hold MODE for two seconds. The 12 hour
valuewillflash.Usethe( )buttontomakeaselectionbetween12hour
and 24 hour format.
3. Press MODEagain, the “hour digits” will flash. Use the ( )button to
enterthe hours.Holding downthebutton willincrease thevaluerapidly.
4. Press MODE again, the “minute digits” will flash. Again, use the
( ) button to change the minutes.
ENGLISH
FIG.A
FIG.E
FIG.D
FIG.F
FIG.C
FIG.B
Battery life : approx. 6 hours for continuous radio on.
approx. 1 year for pedometer only.
Product size : 64 x 42 x 32 mm (L x W x H)
Weight : 50 g
MAINTENANCE
1. Do not immerse the unit in water. If the unit comes in contact with
water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive materials. Abrasive
cleaning agents may scratch the plastic parts and corrode the electronic
circuit.
3. Do not subject the unit to excessive: force, shock, dust, temperature, or
humidity.Such treatmentmayresult inmalfunction,a shorterelectronic
life span, damaged batteries, or distorted parts.
4. Do not tamper with the unit’s internal components. Doing so will
terminate the unit’s warranty and may cause damage. The unit contains
no user-serviceable parts.
5. Onlyusenewbatteriesasspecifiedinthisinstructionmanual.Donotmix
new and old batteries as the old batteries may leak.
Read this instruction manual thoroughly before operating the unit.
CAUTION
— Thecontent of this manual is subject to change without further
notice.
— Due to printing limitation, the displays shown in this manual
may differ from the actual display.
— The manufacturer and its suppliers held no
responsibility to you or any other person for any damage
expenses, lost profits, or any other claim arise by using this
product.
— Thecontents of thismanual may notbereproduced without the
permission of the manufacturer.
WARRANTY
This product is warranted to be free of defects in manufacturing
for 90 days after purchase. For technical support please call
800-853-8883 (Monday - Friday, 8am-5pm PST).
Defective product returns should be directed to the place of
retail purchase. If this is not posibble all direct returns must
include a Return Authorization Number from Oregon Scientific,
together with proof of purchase date, your name and address,
shipped prepaid to Oregon Scientific Inc.,
19861 SW 95th Place, Tualatin, OREGON 97062, USA.
This warranty does not cover a product subjected to abuse,
misuse or accidental damage.
60 cm
(24 inch)
60 cm
(24 inch) (20 feet)
6 m
PEDOMETER WITH FM RADIO
MODEL : PE316FM
INSTRUCTIONMANUAL
P/N.: 086-001936-10