Ortur Laser Master 2 PRO S2 User manual

Assembly Manual

Y Aluminum Profile-540mm *1
Corner Connectors *2
Scale Mark 0
Pay attention to the notch direction!
1

Scale Mark 0
Scale Mark 0
X Aluminum Profile-460mm *2
M5×25mm Screws *2
2

M5 Profile Nuts *4
Tighten with a 2.5mm Hexagon Wrench
3

Scale Mark 0
Corner Connectors *2
Pay attention to the
notch direction!
Y Aluminum Profile-540mm *1
4

Tighten with a 2.5mm Hexagon Wrench
M5×25mm Screws *2
5

Put X-axis assembly onto the frame
X-axis Assembly *1
Scale Mark 0
Scale Mark 0
6

Base Anchors *2
M5×8mm Screws *4
M5 Spacers *2
Timing Belts *2
Scale Mark 0
7

The timing belt needs to pass through the wheels
8

M5 Profile Nuts *2
Mainboard Assembly *1
Y Limit Switch *1
The timing belt must be tightened and then locked with screw!
M5×8mm Screws *4
9

M5×8mm Screws *1
Cable Loom Fixing Plate 1 *1
M5 Spacers *1
M5 T-nut *1
10

M4×6mm Screws *2
Cable Loom Fixing Plate 2 *1
11

Install Cable Loom
Cable Loom *1
12

M4×6mm Screws *2
Cable Tie *1
13

M4×6mm Screws *2
Cable Tie *1
Ground Wire
The wire terminal must be inserted
into the end of the port！
Black
Red
14

Laser Wire
Y connect to Y-axis motor
L connect laser wire
X connect X
Cable Ties *2 Black Red
Ground Wire
15

X connect to X-axis motor M5×8mm Screws *2
( LU2-4-SF haven't this Focal Gauge & Holder, but a Focal Gauge Board )
Focal Gauge + Gauge Holder *1
Cable Tie *1
M5 T-nut *2
16

Screws *2
Ground Wire
3Pin
Nuts *2
Laser Wire
Cable Ties *2
Thumb Screw *1
17LU2-2/LU2-4-LF Laser Module

Thumb Screw *1
3Pin
Laser Wire
Cable Ties *2
Ground Wire
18LU2-4-SF Laser Module