Outsunny 845-243 User manual

C190923

Step 1: put 2 parts 5 connect with the base part 3 by plastic connector 32
Step 2：:put 12 and 13 connect with 3 by screw

Step 3: slide PC panel G into groove 5 and 12 13
Step 4: connect 19 with 5 by screw 39

Step 5: Slide sunlight panels H into the grooves of 5 and 12,13, then tighten
the screws
Step 6: Connect 8 with 9 by plastic connector 34, then connect 8,9 with 5 by
connector 33-1/33-2

Step 7: Slide PC panel I into grooves of 8,9 ,then connect 21 with 12 and 13,
then tighten the screws
Step 8: The door: Connect 25 and 27 by plastic connector ; slide one PC panel
K into the groove of 27and 28; slide 28 with its groove to connect with K; then
slide the other K into the groove of 26, 28 and 29

Step 9: According to the above step, assemble other side of greenhouse
Step 10 :stand greenhouse, connect 1,2 with front and back by connector 32

Step 12: connect 6,7 with both ends of 5 by plastic connector 33-1/33-2
Step 13: Connect both ends of 23 with 8,9/10,11 by plastic connector 34; slide
the window into the groove of 23;

Step 14: Connect 23 with plastic connector 34 by screw 42
S
tep15: :Connect 16,17,18 with 6 ,7, 23 by screws, but keep the screws loose
for later PC panels assembly; then connect 18 with 24

Step 16: Slide PC panels A(the wall), B(the roof), and J(the roof) into the
grooves of 17and 18, then tighten the
screws

Step 17: Connect dewatering profile with 6,7 by screw;
Connect 31 with 6,7 by screw 38;
Step 18：Push the plastic cover onto the top plastic connector.

Put 44 on inside 4 base corner, then connect screw 46 and 45 fixed in to the
floor