Palm Treo 500 Manual

Treo 500
DISASSEMBLY PROCEDURE
APR 30, 2007

IMPLEMENTS of ASSEMBLY /DISASSEMBLY
a clip a screw driver
(T5)
a pick

BATTERY COVER、BATTERY

ANTENNA COVER
Use the pick to pry antenna cover surround

INNER FRAME
Release the 4 screw at the corner Use the pick to pry up inner frame from middle case.

MPCB (1)
Speaker Rubber
LCD FPC Connector
Keypad Connector
2M Camera Connector

MPCB (2)
Bend the middle case, then be
made the hook release.
Hold the battery connector to take
out MPCB from middle case.

KEYPAD FPC、KEYPAD MODULE
It’s easy to take out the Keypad FPC.
Bending the middle case while push
the behind keypad module.
Take out the Keypad Module.

QWERTY KEY
It’s easy to take out
the Qwerty Key.

KEYPAD COVER
Use the pick to pry the hook
release from middle case. The other side the same

QWERTY KEY
It’s easy to take out
the Qwerty Key.

LCM COVER
The finger press the LCM
cover with force.
Then push the LCM cover to
the leader direction.
The LCM cover is separated
from middle case.
Take out the LCM cover.

LCD PANEL
Bend the middle case, while push the
panel in opposite direction.
Be made the hook release from panel.
Be careful don’t remain the
fingerprints on the panel.
Take out the LCD panel.

Disassembly Finished

Treo 500
LCM COVER & LENS
DISASSEMBLY
APR 30,2007

BATTERY COVER、BATTERY

ANTENNA COVER
Use the pick to pry antenna cover surround

SCREWS on the INNER FRAME
Release the 2 screw at the top inner frame

LCM COVER
The finger press the LCM
cover with force.
Then push the LCM cover to
the leader direction.
The LCM cover is separated
from middle case. Take out the LCM cover.

END