Panamax MIW-DUAL-SIGNAL-BAY User manual

STEP 1:
Select a location close to the equipment. In the case of a at panel
display, the recommended location is one that is behind the device
and hidden from view once the Plasma TV is mounted. Cut a 4”
wide by 3 3/4” high hole in the wall for the mounting bracket.
STEP 2:
Run the signal line(s) through the mounting bracket.
Install the mounting bracket in the hole.
STEP 3:
Remove the rubber plug from one of the Signal Bay Pass-
Throughs. Cut a hole in the rubber plug so that it ts snugly
around the signal line. Pass the signal line through the Signal
Bay Pass-Throughs, place the rubber plug over the signal line,
and put the rubber plug back in place.
STEP 4:
Install the Max In-Wall Dual Signal Bay into the mounting bracket
and secure with the included screws.
Signal Protection Module Usage:
Panamax In-Wall signal protection modules (sold separately),
while not necessary for surge protection in the Max In-Wall Dual
Signal Bay, may be used to provide a clean looking interface for
the signal lines. When used in the proper manner the modules
also provide total protection to the connected equipment.
NOTE:
In order for the signal protection modules to protect against surg-
es, the ground wire on the Max In-Wall Signal Bay may be con-
nected to the ground wire on the Max In-Wall Power-PRO that is
installed nearby (less than 1 foot away). Simply connect it with the
same wire nut that is used to connect the Max In-Wall Power-PRO
to the building wire.
1
PANAMAX MAX IN-WALL DUAL SIGNAL BAY INSTALLATION INSTRUCTIONS
INS00811 REV A 03/07
STEP 5:
Repeat steps 1-4 for the Dual Signal Bay located at the source
components.

2
MAX IN-WALL DUAL SIGNAL BAY SPECIFICATIONS
Summary of Features
Accommodates two blank module inserts with pass-through plugs (included) or two InWall signal
protection modules (sold separately).
Full metal housing
Enlarged faceplates (4.5” x 4.5”) to accomodate oversize wall cutouts.
Fits into many two-gang outlet brackets (old-work, low-voltage, Caddy-brand outlet bracket
(model MPAL2) included.
14 AWG, solid wire connection for bonding / grounding to In-Wall AC units.
Provides an elegant, convenient solution for connecting signal lines from the source device to the
display device when running cables within the building walls.
Specications are subject to changes due to product upgrades and improvements.
•
•
•
•
•
•
CONTENTS CONTACTING PANAMAX
Panamax
1690 Corporate Circle
Petaluma, CA 94954
Phone - 707-283-5900 or 800-472-5555
Fax - 707-283-5901
Web - www.panamax.com
Customer Relations
7:30 AM – 4:30 PM, M-F Pacic Time
Email - [email protected]
One MAX In-Wall
signal bay enclosure
(4) Mounting Screws
(1) Mounting Bracket
Included Installation Accessories: