Panasonic Li-ion EY0L82 User manual

© Panasonic Eco Solutions Power Tools Co., Ltd.
2012. All rights reserved. Unauthorized copying and
distribution is a violation of law.
Order Number PTD1208X03CE
Battery Charger
Model No. EY0L82
Europe
Oceania
TABLE OF CONTENTS PAGE PAGE
1 Warning-------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 5
5 Wiring Connection Diagram ---------------------------------10
6 Schematic Diagram---------------------------------------------10
7 Exploded View and Replacement Parts List -----------11

2
1Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100°F / 600°C).
2 Specifications

3
3 Troubleshooting Guide
3.1. Troubleshooting Guide

4
3.2. Trial Operation (After Checking Troubleshooting Guide)
3.2.1. Assembly
• Confirm if there is no gap between Housing A and B by pinching lead wires or power cord.
• Confirm if the slide terminal cover moves smoothly.
• Confirm if 4 screw caps are attached to a housing B.
3.2.2. Operation
• Confirm if the LED lamp works normally by insert and remove the battery pack.
• Confirm if the power cord does not break by moving the power cord bushing from side to side and up and down.
• There should be no abnormal heating or sound.

5
4 Disassembly and Assembly Instructions
* Please assemble by opposite procedure.
4.1. How to remove screw caps and screws of housing A and B
4.2. How to remove the connector for module and slide battery terminal and
the LED PCB

6
4.3. How to remove the terminal base
4.4. How to remove the terminal base from the housing A

7
4.5. How to remove a Fuse
4.6. How to remove the module from the housing B

8
4.7. How to remove the power cord from the module

9
4.8. Caution for assembly

10
5 Wiring Connection Diagram
6 Schematic Diagram