Panasonic WhisperSense FV-08VQC5 User manual

FV-08VQC5 FV-11VQC5
6 8
9
11
11
11
Centered/

12. Do not install with a method which is not approved in the instructions.

sa
These Panasonic ventilating fan models are equipped with a motion sensor and a humidity
sensor that turn on automatically when motion is detected, when humidity increases rapidly,
or when humidity rises above a 30% 80% relative humidity set-point. It is user-adjustable to
operate 0.5 60 minutes after the sensors are no longer detected.
~
~

Motion sensor unit
11
Humidity sensor unit
3 7/8(98)
Main control circuit
Red
Red
Yellow
Yellow
White
White
White
Black
Humidity sensor
Fan body
Red
White
Black Black
Green
Humidity setting
Motion sensor
Red
White
White
Capacitor
Motor Black
(114 C Fuse in Motor)
lmpedance-protected
Live
Neutral
( )
VENT.
Junction box
AC120V
60Hz
(Power supply)
Adjustment
switch
White
Black
Green
(Earth ground)
Timer

Humidity preset switch positions (Tolerance:±10%)
30%
~~ ~ ~ ~ ~ ~
~ ~
40% 50% 60% 70% 80%
MIN MAX
Factory setting: 50% RH (" " means "about")
Position : refer to 0.5 minute
Timer
Timer preset switch positions
Humidity
preset switch
Timer
preset switch
Motion sensor detectible
condition
Humidity
decreasing about 5%RH
sensor detectible condition
(a) rapid to moderate humidity increases and (b) humidity above a 30% 80% relative humidity
set-point. (a) and (b) are set with "HUMIDITY SETTING" adjustment. Fan may occasionally turn
on when environmental conditions change. The "TIMER" controls how long the fan remains on
(a) after rise in humidity and (b) humidity level is below the set-point .
Panasonic ventilating fan
responds to:
(1) Motion sensor detectible
condition.
(2) sensor detectible
condition.
Humidity
2. Long-time operation will influence the detecting precision as dust . Humidity
preset switch need to be adjusted.
accumulates
may
1. If this unit is to be install over a tub or shower, for best results, locate it near the shower
head.
Stop
Remains running
until the delay time
has passed
The delay time is determined
by timer preset switch.
The unit running for
an adjustable duration
of 0.5 to 60 minutes, after
motion is no longer detected.
continues
Human
activity
Fan activity
Room temperature is
25 (77 F).
MIN
~30%
AXM
~80%
MIN
~30%
MAX
~80%
~

Motion sensor
unit
6

Motion sensor
unit
page 4
7

9. Adjust timer preset switch and humidity preset
switch (Fig.7). Refer to switch indication on page 5.
(3 po itio ) Fig.6).s n (
fix
8

9
CENTERED/

4. Do not use cleaning sprays, solvents, or water on
or near the . sensors
10
Remove grille by pulling down the mounting spring
opposite the sensor lead.