Patio Heater Instructions
OZGLOW F40 Permanent Installation
IMPORTANT INFORMATION REGARDING UNIT
This Ozglow heater is to be installed to the
requirements of all local gas authorities. For all
other installation requirements refer to code AG
601 - gas installations.
The OZGLOW F40 patio heater is for use with
natural gas or propane gas. Gas pressure details
are on the appliance data plate fitted above the
gas valve. Gas type must be specified at time of
order.
GENERAL MAINTENANCE
oThis OZGLOW heater should be checked at least once each year by a qualified
service person.
o This OGLOW heater is to be placed on level, stable surfaces.
oThis OZGLOW heater should be inspected before each use. Particular attention
should be given to the hose assembly to make sure there is no signs of damage or
wear and tear.
oIf the flame becomes excessively long and yellow or if soot builds up on the emitter
mesh turn the heater off and call a qualified service person.
o Keep this OZGLOW heater free of cobwebs and as dust free as possible.
oIf the flame becomes excessively long and yellow, or if soot builds up on the emitter
mesh, turn the heater off and call a qualified service person.
oIf this OZGLOW heater will not light or cannot be adjusted to operate correctly,
contact your local authorised dealer or your local gas authority.
© PARASOL HEATERS AUSTRALIA
MELBOURNE 61 3 9549 4466 | SYDNEY 61 2 9624 4486 | BRISBANE 61 7 3200 7877
www.parasolheaters.com.au
Created on 24/09/2015 Page 4 of 11
