2
© 2014 - 2024 Parktron Technology Ltd.
Table of Content
1. Cabinet installation (Entry/Exit Terminal):..................................................................4
1.1. Shipping package: ..................................................................................................... 4
1.2. Foundation island preparation: ................................................................................ 5
1.2.1. Suggested dimensions: ................................................................................. 5
1.2.2. Power, network cable, control signal & intercom wires:.............................. 6
1.2.3. Anchor bolts: ................................................................................................ 6
1.3. Detection loop wire installation: .............................................................................. 8
1.3.1. Suggested loop wire specification: ............................................................... 8
1.3.2. Loop position and wiring guide:................................................................... 8
1.3.3. Ground slot cutting for loop wire installation: ............................................. 9
1.3.4. Loop wire installation instruction:.............................................................. 11
2. Cable & wire connection:......................................................................................... 12
2.1. Connect loop wires to loop detectors: ................................................................... 12
2.1.1. Where are loop detectors?......................................................................... 12
2.1.2. Loop wire connection to loop detector:..................................................... 12
2.1.3. Loop detector configuration & testing: ...................................................... 13
2.2. Connect barrier gate to terminal:........................................................................... 14
2.2.1. Terminal I/O control board wiring contact points reference:..................... 14
2.2.2. Barrier gate wiring diagram (for Parktron barrier AGT210): ...................... 16
2.2.3. For other types of barrier: .......................................................................... 18
2.3. DC power outputs of terminal device & signal inputs:........................................... 21
2.3.1. Wiring contacts for fixed functions: ........................................................... 21
2.3.2. Wiring contacts for software programmable functions:............................ 22
2.4. Intercom wiring reference:..................................................................................... 23
2.4.1. Wiring diagram example: ........................................................................... 23
2.4.2. Parktron intercom sub unit: ....................................................................... 23
2.4.3. Master unit requirement:........................................................................... 24
2.5. Network cable connection: .................................................................................... 24
2.5.1. Connector location: .................................................................................... 24
2.6. Input power cable connection:............................................................................... 25
2.6.1. Terminal input power requirement:........................................................... 25
2.6.2. Input power connection location: .............................................................. 25
3. Power on & configuration:....................................................................................... 26
3.1. Factory default IP addresses:.................................................................................. 26
3.2. Preparation for configuration (How to connect terminal with Putty.exe): ............ 26
