Parrot UNIKA User manual

Parrot UNIKA for HONDA CIVIC
Parrot UNIKA is a universal interface that allows you to control the Parrot MKI9200 directly with the
OEM steering wheel commands. Parrot UNIKA can work with car protocols such as CAN, KBUS or
resistive systems.
Before installing the UNIKA, make sure you have the latest software update on
your Parrot MKI9200.
If you have a Parrot MKi9100, make sure you also have the 3.1 display version. To
do so, select Settings > Advanced settings > Information.
Installation
Compatibility Car models HONDA CIVIC > 2006
Parrot reference For Parrot MKI9200
Parrot UNIKA: PI090020AB

The power supply for the UNIKA interface is taken from the power cable
of the Parrot MKi. It is important to follow the color code of the power
cable wires: the red wire of the kit’s cable corresponds to the permanent
12V supply; the orange wire corresponds to the ignition 12V ; the black
wire is for ground ; the yellow wire corresponds to the Parrot mute output.
Warning : Connect the ignition to the Parrot car kit if the vehicle is
based on a resistive or a K-Bus protocol. Don’t connect the ignition
if the vehicle is based on a CAN protocol.
On some vehicles, the 12V power wires may be reversed, in which case
you must reverse the red and orange wires of the hands-free kit’s power
supply. This can easily be done by reversing the two fuse holders on the
kit’s power cable.
Power supply
We recommend you to install the Parrot MKi before installing the
UNIKA. Make sure the installation is correctly performed by checking if the
«Good bye» message is displayed when you turn off the ignition.
► Refer to the documentation of your Parrot MKi for more information.
Installation of
the Parrot MKi
Selecting the
protocol
Use the DIP switches located on one side of the UNIKA to select the
protocol (resistive or CAN Bus / KBus) on which the vehicle is based.
Warning: Make sure the UNIKA is not powered before selecting the
protocol.
Installation
Set the DIP this way if you have an OEM radio.
12V ignition is not provided.
Get the 12 V ignition from the car.
Set the DIP this way if you don’t have an OEM radio.

Resistive protocol
The wires corresponding to the resistive protocol must be connected correctly to your car
stereo’s. It is important to follow the wiring diagram for your vehicle.
In case of problem or if you have installed the UNIKA interface in another
car, reset the UNIKA by holding down the Reset button until the LED turns
off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (re-
sistive protocol). You can then release the reset button.
Reset
procedure
Once your UNIKA interface has been fitted, the LED should light up green
and should turn amber while pressing a button on your steering wheel.
If the LED does not light up, check the power supply connections. If the
LED is red or blinks red, check the connections.
Checking the
wiring
Warning : Once the installation is complete, turn the ignition off until the UNIKA LED
switches off.

Parrot MKi9200
UNIKA
yellow & red
yellow & blue
cap
music cable
screen
www.parrot.com
brown/
black & green/
red
ground K-Bus Can High Can Low V 1 V2
Car Radio
Mute in 1 2 3
Mute
red
black

RESIS Configuration HONDA
The wires corresponding to the RESIS protocol must be connected correctly to your car stereo’s
RESIS information. It is important to follow the wiring diagram for your vehicle. We would advise our
customers to have the interface fitted by a professional.
If your car stereo supports mute signal management, then your actions on the steering wheel
commands while using a Parrot MKI9200 will not be taken into account by the car stereo.
To find out the mute position of your car stereo, refer to the documentation of your device or contact
the car manufacturer.

If you do not have 7 buttons on your steering wheel, hold down the last
button for two seconds until the LED turns green.
Specific case
Warning : Once the installation is complete, turn the ignition off until the UNIKA LED
switches off.
1- Programming Parrot UNIKA for your car
The wires corresponding to the resistive protocol must be connected correctly to your car
stereo’s. It is important to follow the wiring diagram for your vehicle.
If your vehicle is based on a resistive protocol, you have to define the
mode manually:
1. Turn the ignition on.
> The LED blinks red once.
2. Press the buttons on the steering wheel in the following order:
s r c .
> Each time you press a button, the LED blinks in red.
Defining the
mode
In case of problem or if you have installed the UNIKA interface in another
car, reset the UNIKA by holding down the Reset button until the LED turns
off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (re-
sistive protocol). You can then release the reset button.
Reset
procedure
Your system runs on B mode.

The wires corresponding to the resistive protocol must be connected correctly to your car
stereo’s. It is important to follow the wiring diagram for your vehicle.
In case of problem or if you have installed the UNIKA interface in another
car, reset the UNIKA by holding down the Reset button until the LED turns
off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (re-
sistive protocol). You can then release the reset button.
Reset
procedure
Once your UNIKA interface has been fitted, the LED should light up green
and should turn amber while pressing a button on your steering wheel.
If the LED does not light up, check the power supply connections. If the
LED is red or blinks red, check the connections.
Checking the
wiring
Warning : Once the installation is complete, turn the ignition off until the UNIKA LED
switches off.
Resistive protocol

Enter the menu / Entrer dans le menu / Entrar en el menú / Öffnen
eines Menüs / Accedere al menu / Het hoofdmenu openen
/
Navigate through the menus / Naviguer dans le menu / Navegar por
los menús / Navigation in den Menüs / Consente di utilizzare i menu /
In de menu’s navigeren
s r c Confirm menu choice / Confirmer / Validar la selección / Bestätigung
einer Auswahl / Confermare la selezione / De selectie valideren
s r c Back menu / Menu précédent / Menú anterior / Rückkehr zum vorherge-
henden Menü / Consente di tornare al menu precedente / Vorige menu
/ Adjust the volume / Modifier le volume / Ajustar el volumen / Einstellung
der Lautstärke / Modificare il volume / De geluidssterkte regelen
s r c
Answer an incoming call / Répondre à un appel / Descolgar una llamada
/ Entgegennehmen eines eingehenden Anrufs / Rispondere a una chia-
mata / Een inkomend gesprek opnemen
s r c
Refuse an incoming call / Refuser un appel / Colgar una llamada / Been-
den eines eingehenden Anrufs / Rifiutare una chiamata / en inkomend
gesprek weigeren
s r c Hang up / Raccrocher / Rechazar / Ablehnen / Riagganciare / Ophangen
s r c Discreet mode / Mode discret / Modo discreto / Diskreter Modus / Mo-
dalità privata / Privacy modus
s r c s r c
Exit discreet mode / Sortir du mode discret / Salir del modo discreto /
Beenden des Diskreter Modus / Disattivare la modalità privata / De dis-
crete modus opheffen
s r c s r c
Start the voice recognition feature / Lancer la reconnaissance vocale /
Iniciar el modo de reconocimiento de voz / Aktivieren der Spracherken-
nung / Attivare la funzione di ricon. vocale / De modus Spraakherken-
ning sluiten
s r c Redial function / Fonction Bis / Función de rellamada / Wiederholung
des letzten Anrufs / Funzione Bis / Bis functie
Mute Mic / Couper le microphone / Desactivar el micrófono / Das Mikro-
fon deaktivieren / Disattivare il microfono / De microfoon in- of uitscha-
kelen
/ Next - previous track / Morceau suivant - précédent / Pista siguiente
- precedente / Vorhergehende - nächsten Stück / Brano precedente -
successivo
Play - Pause / Parar - reproducir música / Anhalten - Fortsetzen der
Wiedergabe / Interrompere - riprendere la lettura /
Mode B s r c

Depending on the steering wheel control in your vehicle, the UNIKA
interface will enable you to take full advantage of the telephone and music functions in 4
different modes: Mode A (4 buttons), Mode B (5 buttons), Mode C (6 buttons) and Mode D
(7 buttons).The selection of this mode depends on the protocol of the vehicle.
Note : Pictograms on the buttons depend on the model of the vehicles.
2 - Features
Warning : The mode you will use depends on the number of available buttons and not on
the pictograms. For instance, if you have the buttons, you will use the
UNIKA in mode B : consider the s r c buttons is replaced by the button.
Short press
Long press
Volume
2 short presses
Seek
s r c Source
Pick up - Hang up