PawHut D00-119BN User manual

2. Install inner carrier lining by zipping the removable piece.
(Fig. 2)
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
For Pet Use Only!
Check that you have all the parts for this model
before assembling the stroller
ASSEMBLING CARRIER
1.Push out the support rods to each end until they are
locked into place. (Fig 1)
INdab017_UK_D00-119
INSTRUCTION MANUAL
FIG 1.
FIG 2.

UNFOLDING AND FOLDING THE FRAME
NOTE: Please remove the carrier prior to unfolding and folding
the frame
UNFOLDING
3.Hold the sides of the frame with both hands and pull up,
once it clicks it will lock (Fig.3A) Once it is locked, it should
look like(Fig.3B)
FOLDING NOTE: Apply breaks before folding.
4.Slide the white button on the stroller handle to the left then
press the black button on the bottom of the handle with the
same hand (Fig.4A) and push forward to fold (Fig 4B)
Shaped back tube
Locate locking tubes on
the bottom of the carrier.
5.Put the carrier on the stroller frame with tube towards the
front of the stroller. (Fig 5A) Lock the back of the carrier by
placing your finger on the bottom of the frame and pressing
hard on to interlock the pieces as shown in (Fig 5B).
UNINSTALLING CARRIER ON STROLLER
Please remove the pet(s) before uninstalling the carrier, to do
so, reverse the procedures shown in "Installing Carrier On
Stroller."WARNING:Make sure brakes are applied before
installing or removing carrier.
FIG 3A. FIG 3B.
FIG 4A. FIG 4B.
INSTALLING CARRIER ON STROLLER
Shaped front tube
FIG 5A. FIG 5B.