PB TEEN Display-It Dresser User manual

www.pbteen.com
Display-It Dresser
IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions carefully before assembling.
For your safety, assembly by two adults is recommended.
Assembly Instructions:
1. Place the Dresser in its desired location. Insert Shelf Support Pegs (C) into the pre-drilled holes on the
interior sides of the cabinet. Place the Shelf (B) on the Shelf Support Pegs (C).
2. Adjust the Adjustable Levelers on the bottom of the dresser by loosening or tightening them, to place
Dresser evenly on floor.
CARE INSTRUCTIONS:
• Dust with a clean, soft cloth.
• Avoid the use of chemicals and harsh cleaning agents.
Parts Included: Hardware Included:
A - Dresser – 1pc C - Shelf Support Pegs
– 8pcs
B - Shelf – 2pcs
B.
B.
C.
A.
B.
C.

www.pbteen.com
Display-It Dresser
FURNITURE TIPPING RESTRAINT
Young children may be injured by tipping furniture. The use of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection against the unexpected tipping of furniture due
to small tremors, bumping or climbing. We recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.
Hardware Included:
Installation Instructions:
1. Locate a wall stud behind your furniture. Position a Plastic Wall Bracket (E) on the stud approximately 1”
below the top of the furniture. Mark and drill pilot hole into the center of the stud with a 3/32” drill bit.
Attach a Plastic Wall Bracket (E) to the stud with the Long Wood Screws (F) provided.
2. On the back of the furniture, the second Plastic Wall Bracket (E) will need to be attached to the furniture
frame at the top. To do this, temporarily move the furniture into its final position and mark the location of
the wall’s Plastic Wall Bracket (E) on the furniture frame with a pencil.
3. Move the furniture away from the wall and place a Plastic Wall Bracket (E) on the mark. Using the marks
from the previous step as a guide, drill holes for screws with a 3/32” drill bit. Attach the Plastic Wall
Bracket (E) to the furniture with the Short Wood Screws (G) provided.
4. Move the furniture into its final position, taking care to line up the wall’s Plastic Wall Bracket with the
furniture’s Plastic Wall Bracket (E). Thread the Plastic Restraint (D) through the Plastic Wall Brackets (E)
and clinch as shown in the illustration. Tighten strap until snug. Do not over tighten.
D. Plastic Restraint ( 2 pcs )
E. Plastic Wall Bracket ( 4 pcs )
F. Long Wood Screw 3x32mm ( 4 pcs )
G. Short Wood Screw 3x19mm ( 4 pcs )
Long wood screw
Plastic restrain
Plastic wall bracket
Short wood screw