Pentair LINCOLN A Series Owner's manual

LINCOLN MODEL 967
ELECTRONIC LUBE METER
(SERIES “A” )
APENTAIR COMPANY
OWNER/OPERATOR MANUAL
SPECIFICATIONS
ENGLISH METRIC
MAX. FLOW *. ................................ 4g.p.m. 15 liters/min.
MIN.FLOW *. .................................... 0.25 g.p.m. 0.95 liters/min.
OPERATING PRESSURE (MAX.) ............1500 p.s.i. 100 Bar
OPERATING TEMP. (MIN./MAX.) ........... ..0°/150°F. -18°/70°C.
ACCURACY ...................................±0.5 %±0.5%
WEIGHT .......................................3lbs. 1.36 kg.
5DIGIT LCD DISPLAY 5/16” HIGH .............. pt./qt./gal. liters
INLET AND OUTLET CONNECTIONS ......... 1/2” NPTF 1/2" BSPP
LITHIUM BATTERY POWERED (minimum life 2years or more)
*Tested with oil at ambient temperature, Min./Max. flow rates will vary with
fluid viscosity.
1
DESCRIPTION
Model 967 electronic lube meter is de-
signed specifically for dispensing avari-
ety of petroleum products such as mo-
tor oils (S.A.E. 5-50), gear oils (S.A.E.
80-240), automatic transmission fluid, or
anti-freeze (Ethylene Glycol) solution.
Balance, lightweight, ruggedness, and
comfortable grip make it the best choice
for use with overhead reels. Acast alu-
minum housing is coated with aoven
baked epoxy finish to resist scratches.
Magnetic drive prevents any possibility
of leakage contaminating the register
module.
The electronic register module contains
amicroprocessor board powered by a
lithium battery with aexpected life of 2-
5years depending on usage. It can be
programmed to dispense pints, quarts,
liters, or gallons and will totalize in liters
or gallons. Acalibration factor and unit
of measure are programmed in each
meter when it is factory tested. Units
can be electronically re-calibrated in the
field by authorized personnel, when
necessary.
A5digit liquid crystal display, accurate to
the third decimal place, shows the exact
amount of fluid dispensed. The entire
register module is protected from the
wear and tear of normal shop use by a
rugged, glassfilled, Nylon housing.
FEATURES
•
•
•
•
•
•
•
•
•
•
Magnetically driven register
Leakproof
LCD display.
Three decimal point resolution
Electronic calibration.
Totalize in Gallons or Liters.
Dispense in Pints, Quarts,
Liters, or Gallons.
Few moving parts.
Low maintenance costs.
Improved accuracy.
OWNER/OPERATOR
RESPONSIBILITY
It is the owner/operator responsibility to
properly use and maintain this equip-
ment.
The instructions contained in this manual
shall be read and understood by the
owner/operator prior to operating this
equipment.
If an owner/operator does not under-
stand English, the contents of this man-
ual shall be explained in the owner/op-
erator native language to assure the
owner/operator comprehends.
It is the owners/operators responsibility
to maintain the legibility of any warning
and instruction labels.
The owner/operator shall retain this
manual for future reference to Impor-
tant operating and repair Instruc-
tions.
LINCOLNAPENTAIR COMPANY
One Lincoln Way Copyright 1992 Section -F21
St Louis, Missouri 63120-1578 Printed in U.S.A.
[phone] Page -30
FORM 402448

PROGRAMMING DISPLAY
The electronic lube meter liquid crystal
display may be programmed for Eng-
lish or Metric increments. Perform the
following procedure to change the units
of measure.
A.
B.
C,
D.
E.
Remove three screws attaching
register module to the meter
housing.
Press and hold PROGRAMMING
switch located on bottom of mod-
ule. Unit of measure will flash.
Press RESET switch until desired
unit appears.
Release PROGRAMMING
switch.
Reinstall register module in
meter housing and tighten
screws.
OPERATION
After all entrapped air and/or foreign par-
ticles are removed from the supply
line, clean oil continuously passes
through the metering chamber by enter-
ing the inlet port, displacing the piston,
and exiting the outlet port. Each oscilla-
tion of the piston displaces agiven vol-
ume of fluid. Controlled clearances be-
tween the piston and chamber wall in-
sure accurate measurements. As the
piston oscillates, its center hub rotates a
magnet which activates the microproces-
sor.
Depress the RESET button with your
thumb to reset the totalizer to zero before
each use. Squeeze the trigger handle to
dispense the desired amount of fluid.
Total amount used from inventory can
be check periodically by depressing the
TOTAL button If the units dispensed are
pints, quarts, or gallons, the totalizer will
read in gallons. If the units dispensed
are liters, the totalizer will read in liters.
TROUBLE SHOOTING
All meters are shipped with aunit of
measure preprogrammed at the factory.
Abuilt in “error detection” feature will
cause the numbers on the LCD to flash if
the microprocessor does not receive the
proper pulse rate. If this should occur,
the entire register module should be
replaced. Refer to REPAIR.
LIMITED WARRANTY
Lincoln, APentair Company, warrants that lubrication equipment, materials dispensing
equipment and other related equipment manufactured by it will be free from defects in
material and workmanship during the one (1) year following the date of purchase. If
equipment proves to be defective during this warranty period, it will be repaired or
replaced without charge, provided that factory examination indicates the equipment to
be defective. To obtain repair or replacement, it must be shipped, transportation
charges prepaid, with proof of date of purchase to aLincoln authorized Warranty and
Service Center, within the one(1) year following the date of purchase.
This warranty is extended to the original retail purchaser only. This warranty does not
apply to equipment damaged from accident, overload, abuse, misuse, negligence,
faulty installation or abrasive or corrosive materials, or to equipment repaired or altered
by anyone not authorized by Lincoln to repair or alter the equipment. This warranty
applies only to equipment installed and operated according to the recommendations of
Lincoln or its authorized field personnel. No other express warranty applies to lubrica-
tion equipment, materials dispensing equipment and other related equipment manu-
factured by Lincoln.
ANY IMPLIED WARRANTIES applicable to lubrication equipment, materials dis-
pensing equipment and other related equipment manufactured by Lincoln INCLUDING
THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR APARTICULAR
PURPOSE, WILL LAST ONLY FOR ONE (1) YEAR FROM THE DATE OF PUR-
CHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IM-
PLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO
YOU.
In no event shall Lincoln be liable for incidental or consequential damages. The liabil-
ity of Lincoln on any claim for loss or damage arising out of the sale, resale, or use of
lubrication equipment, materials dispensing equipment, and other related equipment
shall in no event exceed the purchase price. SOME STATES DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES,
SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
2

REPAIR
Repair is limited to replacement of listed
service parts. Special procedures and
tools are required. If the register module
is replaced, the lube meter must be
tested and approved in accordance with
appropriate Weight and Measures Stan-
dards before the lube meter can be re-
turned to service. Contact Lincoln Cus-
tomer Service, One Lincoln Way, St.
Louis, MO 63120-1578, [phone]
for your nearest factory authorized
service center.
When ordering replacement parts, list
the part number, description, model
number and series letter.
SERVICE PARTS
ITEM PART
1 242317
2 242318
3 242319
466871-12
568410-14
668410-2
768410-5
868410-4
QTY
1
3
1
1
1
2
1
2
DESCRIPTION
Register Module
Screw
Chamber &Magnet Assy.
O-ring
Housing Cap NPT
Screw
Cam
Quad Ring
ITEM PART
968410-1
10 68410-6
11 68410-25
12 69304-3
13 68410-27
14 242320
15 242321
QTY
1
1
1
1
1
1
1
DESCRIPTION
Trigger Assy.
Sleeve
Valve &Seat
Spring
Screen
O-ring
Adapter
3