Pentair CHLORPLUS PROTECT 10 User manual
3
5
12
4
CHLORPLUS™ PROTECT 10
WATER FILTRATION SYSTEM
INSTALLATION AND OPERATING INSTRUCTIONS
OPERATING SPECIFICATIONS
Pressure Range: 30–125 psi (2.1–8.6 bar)
Flow Rate: 1 gpm (3.78 Lpm)
Capacity: 1,000 gallons (3,785 L)
Temperature Range: 40–100°F (4.4–37.7°C)
PARTS INCLUDED
•
•
•
• O-ring
• Mounting bracket kit
• Screw kit
•
TOOLS AND MATERIALS REQUIRED (not included)
•
• Plumber’s tape
• File
• Pencil
•
•
•
PRECAUTIONS
WARNING:
Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
CAUTION:
Filter must be protected against freezing, which can cause cracking of the
CAUTION:
The rubber O-ring provides the watertight seal between the cap and the
bottom of the housing. It is important that the O-ring be properly seated in the
groove below the threads of the housing or a water leak could occur.
CAUTION:
Because of the product’s limited service life and to prevent costly repairs or
possible water damage, we strongly recommend that the bottom of all plastic
housings be replaced every 10 years for opaque. If the bottom of your housing
has been in use for longer than this period, it should be replaced immediately.
Date the bottom of any new or replacement housing to indicate the next
recommended replacement date.
13845 Bishops Dr. | Suite 200 | Brookeld, WI 53005 | United States
P: 262.238.4400 | Customer Service: 800.279.9404
tech-support@pentair.com | pentair.com
PERFORMANCE DATA SHEET
Substance
Inuent Challenge
Concentration
Max. Permissible Product
Water Concentration
Reduction
Requirements
Average
Reduction
Standard 53
Peruorooctanoic Acid (PFOA) and
Peruorooctane Sulfonate (PFOS) 0.0015 mg/L ± 10% 0.00007 mg/L n/a 98.20%
Flow Rate = 1 gpm (3.79 L/min); Capacity = 1,000 gallons (3,785.41 L) or 12 months
TROUBLESHOOTING
Leaks:
Between Cap and Bottom of Filter Housing:
1.
2.
Do Not Overtighten.
On Inlet/Outlet Connections:
1.
2.
REPLACEMENT PARTS
1.
2. 154101
3. 151120 O-ring, cap
4.
5. 655226-43
6. 151011 UB-1KIT mounting bracket kit
7.
For replacement parts, contact your nearest
5
PENTAIR.COM
7
The ChlorPlus Protect 10 system is certied
by IAPMO R&T against NSF/ANSI 53 for the
reduction of peruorooctanoic acid (PFOA)
and peruorooctane sulfonate (PFOS).
6
pentair.com/assets/residential-ltration-warranty
INSTALLATION CONTINUED
4. [H]
NOTE: Approximately 6" will be
[I]
5. [J] Slip brass compression nut
[K]
pipe.
[L]
6. [M]
water supply [N]. It will be necessary
NOTE: If using mounting bracket, be
sure to slip bracket over screws in wall
(see step 2).
7. [O] Slowly turn on water supply to allow
[P]
[Q]
CAUTION:
If water pipes are used to
ground electrical systems, appliances,
or phones, be sure to install a jumper
with any questions about your home’s
electrical system.
FILTER CARTRIDGE REPLACEMENT
WARNING:
Use safety glasses when
handling household bleach to prevent
bodily injury. Follow bleach manufacturer’s
instructions when handling bleach.
A. [1]
NOTE:
within the household. Fill a bucket with
water to clean housing after it has been
removed.
[2]
to release pressure.
[3]
turning clockwise.
B. [4]
[5]
[4]
NOTE: This step is important to ensure
proper housing seal. Make sure the
O-ring is seated level in the groove.
[5]
C. [6]
DO NOT
OVERTIGHTEN. Make certain cap
[7]
[8]
MAINTENANCE:
C
6
8
7
NOTE:
• For cold water use only
• Do not install where system will be exposed to direct sunlight.
• Make certain that installation complies with all state and local laws and regulations.
•
cartridge are not necessarily in your water. Ask your local water municipality for a copy
of their water analysis, or have your water tested by a reputable water testing lab.
• After prolonged periods of non-use (such as during a vacation) it is recommended
before using.
•
• Spent adsorption media will not be regenerated and used.
INSTALLATION
NOTE:
•
• For installation on standard 1/2" or 3/4" main water line (galvanized, copper or plastic pipe).
•
•
instructions on p.4 before proceeding with installation. See Filter Cartridge Selection
Guide
•
• Numbered diagrams correspond with numbered steps.
1. [A][B] to release pressure in pipes
[C]
2. [D]
mark screw locations on wall. Insert
mounting screws into wall.
[E]
ports.
NOTE:
changes.
3. [F]
DO NOT
OVERTIGHTEN
[G]
NOTE: If using mounting bracket, be
2 3 4
PENTAIR CHLORPLUS PROTECT 10 SYSTEM • INSTALLATION AND OPERATION INSTRUCTIONS
A2
3
1
B
4
5
1
A
B
C
3
FG
E
D
2
4H
I
5
J
K
L
6
N
M
7
O
Q
P
Other Pentair Water Filtration System manuals
Pentair
Pentair Fleck 6700XTR User manual
Pentair
Pentair AZUR User manual
Pentair
Pentair SHURFLO RV-10 SERIES Instruction Manual
Pentair
Pentair FC Series Owner's manual
Pentair
Pentair AUTOTROL 255 Logix 740 User manual
Pentair
Pentair FLECK 9000 SXT User guide
Pentair
Pentair FullFloXF 4000 Series User manual
Pentair
Pentair HIPPO F2200 User manual
Pentair
Pentair STA-RITE SC-75P User manual
Pentair
Pentair 165 User manual
Pentair
Pentair Fleck 5810 XTR User guide
Pentair
Pentair INTELLICHLOR COMSYS-8 User manual
Pentair
Pentair Everpure Claris Ultra Operating instructions
Pentair
Pentair OMNIFILTER QUICK CONNECT T600RO Instruction Manual
Pentair
Pentair FLECK 5812 XTR User manual
Pentair
Pentair FLECK 5800 XTR2 User manual
Pentair
Pentair FLECK 4600 SXT User guide
Pentair
Pentair Predator II User manual
Pentair
Pentair AQUATIC ECO-SYSTEMS ARIAS 6000 User manual
Pentair
Pentair triton TR 100HD Operation manual
Popular Water Filtration System manuals by other brands
Water Control
Water Control Brassmaster Plus+ NitraMAX LS Series Installation & operation manual
ph Miracle
ph Miracle Watermark user guide
Environmental Water Systems
Environmental Water Systems BB 1" SETUP Product and installation manual
EQUATION
EQUATION FS2 SL10 instruction manual
EHEIM
EHEIM 350 Important safety instructions
Genesis
Genesis OPTIMA GO600 System manual
