Perlesmith MD2296 Programming manual

Thank you for choosing our product! This manual applies to full motion
wall mount, we strive to provide the best quality and services for our
customers. Would you kindly share your experience on Amazon if you
are satisfied? Should you have any issues, please don't hesitate to
contact us.
Telephone：[phone] Mon-Fri 10am - 6pm (PST) (USA)
Email：suppor[email protected] (US/CA/DE/UK/FR/IT/ES/JP/AU)
Trouble-shooting Manual
(Full-motion Wall Mount) V1.0

Wrench
For PSSF1, PSXSF1
You can loosen the two nuts to adjust the tilt and move
panel to desired position, then tighten two nuts.
Full-motion Wall Mount
Case
Cables blocked by mount/brackets
Case
TV keeps tilting
For PSCLF
Fasten two bolts in the rear plate with wrench.
Solution 1
Solution 2
Solution 3
Solution 1
Add spacers between bracket and TV back, plug in cable first and
then hang TV.
If VESA less than mount’s max line, please move bracket away
from the cables.
If above solutions cannot help, please contact
[email protected] with information
(TV back pictures, VESA distance, TV weight)for best solutions.
For PSLFK1, PSLFK1-24, PSLFK2, PSXFK1,
PSMFK2, PSMFK1: follow the instruction to make
sure handle operation is correct.
Fasten the screw opposite to
the handle.
TIGHTEN
！
TIGHTEN
！
LOOSEN

Leveling
screws
Full-motion Wall Mount
Case
TV not level or out of balance
Case
Brackets stick out of TV
Solution 1
Check if the wall plate is level with provided bubble level. If the wall
plate not level, adjust it to level.
Solution 2
Solution
Check if the TV plate is level. If the TV plate not level, adjust it to
level.
For PSLFK1, PSLFK2, PSLFK1-24，PSMFK2: this matter you can
use screwdriver to loosen two leveling screws and hold the TV to
adjust the level, and fasten leveling screws tightly.
Move brackets downward, and use upper bolt holes to
attach TV.

For PSXFK1
This matter you can use wrench to loosen two leveling screws and hold the TV
to adjust the level, and fasten leveling screws tightly.
For PSMFK1
This matter you can use screwdriver to loosen the leveling screws and hold the
TV to adjust the level, and fasten leveling screws tightly.
Full-motion Wall Mount
Case
TV not level or out of balance
Use bolt holes at same level, and pull bracket upward to reduce the gap between
the hole and bolt, then fasten them finally.
If above solutions cannot help, please contact [email protected] or
800-5566-806 Mon-Fri 10am - 6pm (PST) (USA)
Solution 3
Solution 4

4
Full-motion Wall Mount
Solution
Case
Arm is stiff to move
Case
Lag bolt is difficult to screw into stud.
Case
Bolts longer than bolt hole on TV
Solution 1
Solution
Apply lubricant to the arm’s joint.
If lag bolt is damaged, please contact customer service for new lag bolt to replace and follow the
installation instruction to ensure:
1.Pre-drill the pilot holes to required length.
2.Use open wrench or socket wrench, rather than electronic tool, which will damage the lag bolt.
Add spacers/ washers to accommodate the bolt length.
If try solution 1, bolts still long, please add 2mm washers(provided in shipping box).
If above fail, please contact us and we will send the suitable screws to you in the first time.