Petsafe Happy Ride WOOD SOFA RAMP User manual

Let’s make home sweet home even sweeter.
WOOD SOFA RAMP

What you have
4
x
2
x
16
x
20
x

1
Attach the support leg foot to the support leg with two long screws and washers.

2
Fit the angled support braces onto the dowels at each side of the support leg.

3
First, attach the angled support braces to the top platform, using four short screws and washers.
Next, attach the angled support braces to the middle platform, using four short screws and
washers. The mounting blocks on the middle platform should be on the side closer to the top
platform. Wait until all the screws are in place before you tighten them.

4
Attach the straight support braces to the middle and bottom platforms with eight short screws
and washers. Wait until all the screws are in place before you tighten them.

5
Attach the angled end of the leg brace extension between the mounting blocks on the back of
the middle platform with a long screw, washer and cap nut. Attach the straight end of the leg
brace extension between the two prongs of the leg brace with the remaining long screw, washer
and cap nut. Before using the ramp, make sure all the screws are fully tightened.

6
Start with the support leg folded and the ramp flat on the floor. Offer treats to encourage your pet
to walk across. Don’t worry if your pet hesitates at first. We all need a little reassurance sometimes!

7
You’re almost there! Fully extend the support leg to set up the ramp. Offer treats to gently
encourage your pet to practice walking up and down.