Petsafe Happy Ride User manual

METAL DOG BARRIER
Sometimes your lap dog needs a little
help holding back his love.
Happy Ride™

What you have
3
x
6
x
6
x
6
x
6
x
6
x
2
x2 x
2
x
2
x
2
x
12
x

1
Remove the threaded rod and short, black plastic spacer from
inside each of the two straight tubes. Discard the two plastic
spacers.

2
Push an oval cap firmly onto one end of each straight tube.
Slip three mounting brackets onto one straight tube with the
hexagonal holes all facing the same side. Slip three mounting
brackets onto the other straight tube with the hexagonal holes all
facing the opposite side, so the two tubes mirror each other.

3
Insert a short bolt through each mounting bracket, fitting the bolt
head into the hexagonal hole. Screw a small wingnut onto each
bolt. Leave these loose for now; you’ll adjust them soon.

4
Screw a large wingnut onto the uncapped end of each threaded
rod. Twist a round cap tightly onto the same end of each threaded
rod.

5
Insert a long bolt through each of the clamp halves with blue
buttons, fitting the bolt head into the hexagonal hole. Position
two of these clamp halves with the blue buttons facing the same
direction, then set an extendable oval tube across them. Make sure
one clamp half is on the extendable (thinner) section of the oval
tube.
Repeat these steps with the remaining oval tubes and clamps.

6
Set the other half of each clamp over the bolt and secure it with a
small wingnut. Leave these loose for now; you’ll adjust them soon.
Repeat these steps with the remaining oval tubes and clamps.

7
Insert a threaded rod into each hollow tube to form a pair of
upright supports. Stand them up with the round bottom caps on
the floor, spaced evenly across the width of your vehicle. Rotate
each large wingnut to adjust the height until each oval top cap is
pressed firmly into the ceiling. Both upright supports should now
stand securely on their own.
Adjust the mounting brackets so the flat rectangular slots all face
you; these are where you will mount the oval tube clamps.