Phanteks GLACIER C350AP User manual

GLACIER C350ap MANUAL V1.0
STEP 1. REMOVE THE ORIGINAL PLASTIC CLAMPS
PH-C350ap_BK01
INSTALLATION for socket AM4
PACKAGE CONTENTS
C350ap Block
Socket Screws for:
- AM4
Acetal Stando
Thermal Compound
(PH-NDC_01)
4x
4x
STEP 2. INSTALLING THE SOCKET SCREWS
Place and tighten the four (4) included socket screws by hand
on the AM4 socket.
Use a Philips-head screwdriver to remove the four (4) screws
(in red). Remove the plastic clamps from the motherboard and
make sure the original AMD backplate stays in place.
DISCLAIMER - This product is intended for advanced users.
Please consult with a qualied technician for installation. Phanteks
assumes no liability for any damages occurring as a result of using
Phanteks cooling products.
WARNING - Power down the system before installation.
- Do not disassemble the waterblock. Warranty will be voided.
- Perform a leak test before turning on the system.
- Check our website for the latest installation guide.
STEP 3. INSTALLING THE ACETAL STANDOFFS
Place the four (4) included Acetal Standos onto the
socket screws.

GLACIER C350ap MANUAL V1.0
STEP 4. APPLYING THERMAL COMPOUND
FINAL STEP. POWER ON
Please check the following:
- Make sure the block is seated properly on the CPU.
- Always perform a leak test before turning on the system.
- Use paper towels under ttings and joints to avoid damage.
- Make sure all hardware has been tested before starting your
water loop.
Make sure the CPU is clean and clear of any residual traces of thermal paste.
Apply a dot (4-5mm size) of Phanteks thermal compound on the center
of the CPU surface.
Let the pump run for multiple hours. Tilting the system
can help to release air bubbles.
STEP 5. INSTALLING THE C350ap Block
Remove the protective lm on the copper base rst.
Place the C350ap block on the CPU and tighten the thumb-screws by hand.
Thanks to the C350ap’s symmetrical design. Both ports can be used as
an inlet or outlet for the water loop.
By securing the screws in a diagonal sequence, the mounting pressure
will be distributed evenly. This optimizes the cooling performance.
Do not use force to overturn the thumb-screws. Please stop when
the screws are at a natural stop.