Setup
2
1 In standby mode, press and hold TIME
SET/AUTO SCAN for 2 seconds.
» The hour digits begin to blink.
2 Press TUNING +/- to set the hour.
3 Press TIME SET/AUTO SCAN.
» The minute digits begin to blink.
4Press TUNING +/- to set the minute.
5Press TIME SET/AUTO SCAN to
confirm.
» The week day digits begin to blink.
6Press TUNING +/- to set the week day.
7Press TIME SET/AUTO SCAN to
confirm.
Set clock
A
1In the tuner mode, press and hold TIME
SET/AUTO SCAN for more than 2
seconds to activate automatic program
mode.
» All available stations are programmed
in the order of waveband reception
strength.
» The first programmed radio station is
broadcast automatically.
2Press PRESET +/- to select a preset
number.
E Tip
Detailed functions and features are•
described in the user manual.
Program and listen to radio
stations
APlay from iPod B
Setup
2
Set the alarm timer
BSet alarm mode
1Adjust the WAKE TO iPod/RADIO/
BUZZ control to select the source for
the alarm.
» When the alarm time comes, the
selected iPod, radio or buzzer turns on.
Activate and deactivate the alarm timer
1Press ALARM 1 or ALARM 2 repeatedly
to activate the timer.
» If the timer is activated, or
is displayed.
To deactivate the alarm timer, press•
ALARM 1 or ALARM 2 repeatedly
until is displayed.
» If the timer is deactivated, or
disappears.
Repeat alarm
1When the alarm rings, press REPEAT
ALARM/BRIGHTNESS CONTROL.
» The alarm repeats ringing minutes later.
E Tip
You can press• TUNING+/- to adjust
interval to repeat alarm.
Stop alarm ring
1When the alarm rings, press the
corresponding ALARM 1 or ALARM 2.
» The alarm stops but the alarm settings
remain.
1Push to open the dock compartment.
2Place the iPod in the dock.
3 Press SOURCE repeatedly to select iPod
source.
» The connected iPod plays automatically.
To pause/resume play, press• .
To skip to a track, press• / .
To search during play, press and hold•
/ , then release to resume normal
play.
Enjoy
2
3
1Ensure that you have set the clock
correctly.
2 Press and hold ALARM 1or ALARM 2
for 2 seconds.
» or and hour digits begin to
blink.
3Press TUNING +/- repeatedly to set the
hour.
4Press ALARM 1 or ALARM 2 to
confirm.
» or and minute digits begin
to blink.
5Repeat steps 3-4 to set the minute.
6Repeat steps 3-4 to select whether to ring
alarm on weekdays or at weekend.
» “L XX(volume level)” begins to blink.
7Repeat steps 3-4 to set the maximum alarm
volume.
DC190_12_QSG_EN.indd 5-7DC190_12_QSG_EN.indd 5-7 4/16/2009 5:57:41 PM4/16/2009 5:57:41 PM
