Philips HR2828 User manual

juice extractor
serving pitcher
HR2828

IMPORTANT SAFEGUARDS
When using electrical appliances,basic safety precautions
should always be followed including the following:
Read all instructions before using.
1. To protect against electrical shock,do not immerse
cord,plug,or Juice Extractor in water or other liquid.
2. Close supervision is necessary when any appliance is
used by or near children or invalids.Never leave an
appliance unattended when in use.
3. Unplug from outlet when not in use,putting on or
taking off parts and before cleaning.To unplug,grasp
plug and pull straight out from outlet.Never pull cord.
4. Avoid contacting moving parts.Keep fingers or
objects other than food out of the food chute.
5. Do not operate this appliance with a damaged cord
or plug,or after the appliance malfunctions,or has
been damaged in any manner;return the Juice
Extractor to the retail location where it was
purchased for examination,repair,or adjustment.
6. Use this appliance only for its intended use as
described in this manual.Do not use accessories or
attachments not recommended by Philips Electronics
NorthAmerica Corporation as they may cause fire,
electric shock or injury.
7. Do not use outdoors or operate where oxygen is
being administered or in the presence of explosive
and/or flammable fumes.
8. Do not let cord hang over edge of table or counter,
or touch hot surfaces-including the stove.
9. This appliance is intended for household use ONLY;
it is not for commercial or industrial use.

10. Any service of the Juice Extractor should be performed
by the retail location where it was purchased.
11. To disconnect the appliance, press the "ON/OFF"
switch to OFF(O),then grasp plug body and remove
plug from electrical outlet. Never yank or twist cord
to unplug.
12. Always make sure Juice Extractor cover is
clamped and locked securely in place before
motor is turned on. Do not open lid while
Juice Extractor is in operation.
13. Be sure to turn switch to OFF (O) position
after each use of the Juice Extractor. Make sure
the motor stops and the sieve stops rotating
completely before putting on or taking off
parts or disassembling.
14. Do not put your fingers or other objects into
the Juice Extractor opening while it is in
operation. If food becomes lodged in opening,
use food pusher or another piece of fruit or
vegetable to push it down.When this method is
not possible,turn motor off (O),wait until sieve
stops rotating completely and unplug before
disassembling Juice Extractor to remove the blockage.
15. Check the sieve after each use. If sieve becomes
cracked or damaged,do not continue to use the
appliance. Shredders on bottom of sieve are sharp,
handle carefully.
16. Do not operate or place any part of this appliance on
or near any hot surfaces such as gas or electric burner
or in a heated oven.

SAVETHESE
INSTRUCTIONS
SPECIAL INSTRUCTIONS
The Juice Extractor has a short cord to reduce the
hazards of becoming entangled in or tripping over a longer
cord.An extension cord may be used if the rating is equal
to or greater than the rating of the Juice Extractor. Use an
extension cord rated 13 amperes or greater.Care must be
taken to arrange extension cord so that it will not drape
over countertop or tabletop where it can be pulled on by
children or tripped over unintentionally.
Operating the Juice Extractor and another appliance at
the same time from the same electrical circuit could cause
an electrical overload condition, which would blow the
fuse or trip the circuit breaker.
SPECIAL POLARIZED PLUG
INSTRUCTIONS
This Philips Juice Extractor has a polarized plug (one blade
is wider than the other).To reduce the risk of electric
shock:
• Plug will fit into polarized outlet only one way.
• If plug does not properly fit outlet at first,reverse it.
• If plug still does not fit,contact a qualified electrician.
DO NOT ATTEMPTTO DEFEAT
THIS SAFETY FEATURE

Table of Contents
Features 2
Preparing theAppliance for Use 3
Ingredients andTips 4
Using the Juice Extractor 4-5
Cleaning 5-6
ForAssistance 7
Warranty Back Cover

2
Features
FoodTray
Stainless Steel
Sieve/Shredders
• Cord Storage
• 2Way Safety Lock System:Both serving pitcher and pulp
container cover must be locked into their respective
positions before unit will operate.
2Way Safety
Lock System
Pusher
Serving Pitcher
2 1/2 Cups/600 ml
capacity
Pulp Container
Food Chute
Lid
ON /OFFSwitch
(I)/(O)

3
Preparing theAppliance for Use
Before first use, wash the serving pitcher, pulp container, sieve
(CAUTION:Shredders on bottom of sieve are sharp), lid, food tray,
and pusher in warm soapy water. Rinse clean and dry thoroughly.
Keep the appliance out of the reach of children and do not let
it run unattended.
C1Put the serving pitcher in place on motor unit and turn
the handle in the direction of the arrow until the serving
pitcher will not go any further and locks into place.For safety,
the Juice Extractor will not operate unless the serving pitcher
and lid are securely locked into position.
C2Put the pulp container on the serving pitcher.
Make sure that the recesses of the pulp container cover the
projections on the serving pitcher.
C3Place the sieve in the middle of the pulp container.
C4Put the lid on the pitcher and turn it in the direction of the
arrow until it will not go any further and locks into place.
The projection of the lid now covers the handle of the serving pitcher.
NOTE: For safety, the Juice Extractor will not operate unless the
serving pitcher and lid are securely locked into position.
C5Put the food tray on the lid.
6Plug the Juice Extractor into a 120VAC electrical outlet.
2Way Safety
Lock System

4
OIngredients andTips
• Use fresh fruit and vegetables as they contain more juice.
Pineapples, beet roots, celery stalks, apples, cucumbers, carrots,
spinach, melons, tomatoes, oranges and grapes are particularly
suitable for processing in the Juice Extractor.
• You don’t have to remove thin peels or skins. Only thick peels,
e.g. those of oranges, pineapples and uncooked beet roots need to
be removed before processing. Peel any waxed fruit or vegetable.
Also remove the white pith of citrus fruits because it has a
bitter taste.Trim away any bruised or discolored parts.
• When preparing apple juice, remember that the thickness of the
apple juice depends on the kind of apple you are using.Some kinds
of apples are more juicy, while others produce a thicker juice.
Choose a kind of apple that produces the type of juice you prefer.
• Apple juice turns brown very quickly.You can slow down this
process by adding a few drops of lemon juice.
• Fruits that contain starch, such as bananas, papayas, avocados,
figs and mangoes are not suitable for processing in the Juice
Extractor. Use a food processor, blender or bar blender to process
these fruits.
• Leaves and leaf stalks of lettuce can also be processed in the
Juice Extractor. Leafy greens or sprouts should be rolled into tight,
compact balls before putting in chute.
• Drink the juice immediately after you have extracted it. If it is
exposed to air for some time, the juice will lose some of its taste
and nutritional value.
• Remove large hard pits, seeds and stones from fruits (cherries,
peaches. pears, etc.) or vegetables before processing.
and nutritional value.
Using the Juice Extractor
1Wash the fruit and/or vegetables,remove hard pits,and cut
them into pieces that will fit into the food chute.
2Turn the appliance on by pressing the ON/OFF (I) switch.
The appliance will only function if the serving pitcher and the lid
have been properly mounted onto the motor unit and securely
locked into position.
C3Put the food pieces in the food chute and press them gently
down using the pusher.
Do not exert too much pressure on the pusher; this could affect
the quality of the end result and it could even cause the sieve to
come to a halt.
NEVER PUT YOUR FINGERS OR AN OBJECT
INTHE FOOD CHUTE.

5
4When the flow of juice into the pitcher has stopped,turn the
appliance off by pressing the on/off (O) switch and WAIT
UNTILTHE SIEVE HAS COMPLETELY STOPPED ROTAT-
ING.
Do not fill the pitcher beyond the MAX indication to prevent juice
from being spilt. If you want to extract a large quantity of juice, empty
the reservoir at a certain point during the process.
Do not let the appliance run continuously for more than two minutes.
If you have not finished extracting juice, turn the appliance off by
pressing the on/off (O) switch and allow it to cool down for two min-
utes before you continue.
5If the pulp container becomes full before you are finished,
turn the Juice Extractor off (O) and follow the directions
below to empty it.
C6Pour out the juice.
It is not necessary to disassemble the Juice Extractor.
If the pulp container is full:
1Turn the appliance off by pressing the on/off (O) switch and
WAIT UNTILTHE SIEVE HAS STOPPED ROTATING
COMPLETELY.
2Empty the pulp container.
3Reassemble the Juice Extractor and continue.
. least 1˝ (3 cm) from heating elements.
Cleaning
• Turn the appliance off by pressing on/off switch off (O) and unplug
the cord from the electrical outlet and WAIT UNTIL SIEVE HAS
COMPLETELY STOPPED ROTATING before you start cleaning
the appliance or removing parts.
• Do not use abrasive cleansers, scourers, wire wool, acetone,
alcohol, etc. to clean parts.
1Remove the parts from the motor unit.
2Clean the parts that have been in contact with food in
hot soapy water immediately after use and rinse them
with hot water. Dry all parts.
Do not put any of the parts in the dishwasher.

6
C3To clean the sieve,use a soft brush.Be careful of the sharp
shredders located on the bottom of the sieve.Do not use a
metal brush.Allow sieve to air dry thoroughly.
4Clean the motor unit with a damp cloth.
Never immerse the motor unit in water or rinse it under the tap.
5When storing the Juice Extractor,do not place the serving
pitcher on the base unit in the locked position.
NOTE: Over time, parts may discolor especially from juicing
carrots and tomatoes.