
General
1.1 Packaging / Transport
1.1.1 Transporting the Unit
In order to ensure save transportation of PHYSIOTHERM-S, the original packaging should
be used for transportation. This particular packaging offers the protection required for
the transport of the unit in an upright position. Protection is not ensured for flat
transportation, which may result in the unit being damaged and impaired in its function.
The authorized dealer or the owner is responsible for proper packaging and needs to
ensure that all safety and accident prevention requirements are met.
1.1.2 Unpacking the Unit
The unit is generally delivered with the packaging material supplied by the manufac-
turer. Since the unit's weight is about 60 kg, it must be unpacked by at least two
people!
Proceed as follows:
•Position the transport packaging so that the UP mark is pointing upward.
•Remove the safety straps from the transport packaging.
•Lift the upper part of the transport packaging and remove it from the unit.
•Remove the top part of the foam material.
•Lift (at least two people) the unit from the lower part of the packaging.
1.1.3 Packing the Unit
The unit should always be transported in its original packaging. Since the unit's weight
is about 60 kg, it must be packed by at least two people!
Proceed as follows:
•Bend down both electrode arms.
•Affix the lower part of the transport packaging to the pallet.
•Place the bottom part of the foam material into the lower part of the transport
packaging, the square cut-out facing up.
•Put the unit into the square cut-out (at least two people are required!) of the bot-
tom part of the foam material.
•Pack all accessories separately. They may be placed in the space left by the unit (be-
tween the case and the operating panel) and shipped within the transport
packaging.
•Place the protective cover (if available) over the unit.
•Now place the top part of the foam material over the unit.
•Put the upper part of the transport packaging over the unit packed in the foam ma-
terial and slide it over the lower part of the packaging.
•Secure the complete packaging (upper + lower part of packaging + pallet) with
safety straps.
4 PHYSIOTHERM-S - Service Manual