PicoBrew Z Series User manual

You Will Need:
• Two Each: Heating Module (Box #1)
and Ingredients Module (Box #2)
• Included T20 driver
PICOBREW Z SERIES
ASSEMBLING YOUR Z2
Information Online
For a complete set of operating
instructions, please refer to the online
manual for your Z Series brewing machine
at: www.picobrew.com/ZManual
Build Unit 1 as shown in the Z1 Quick Start
Guide. This will be the bottom unit of your Z2.
Assemble the Base Z Unit First
1
3
2Remove the 4 Screws on the Top of your
already assembled base unit.
ZN Assembly
Prepare the Top Z Unit
For the Ingredients Module of the top unit, remove the oor by unscrewing
the 7 Screws connecting the Ingredients Module walls to the oor.
V.19.93.15
UNSCREW 7
SCREWS
REMOVE FLOOR
& PROCEED
REMOVE RUBBER MAT
TO EXPOSE SCREWS

All rights reserved. No part of this publication may be reproduced, stored in
retrieval systems or transmitted in any form or by any means electronic or
mechanical, including, photocopying, record or any information storage and
retrieval systems, without the written permission in writing from the copyright
owners. Printed in Seattle, WA, USA
www.picobrew.com
Produced by:
PicoBrew Inc.
2121 N 35th St.
Seattle, WA 98103
© 2019 PicoBrew
Stack the oor-less Ingredients Module on top of the base Z Unit and
assemble with 4 screws.
Stack the Heating Module on top and nish assembly just as you did with
the rst unit.
Congratulations, your Z2 is Assembled! Follow instructions included in Box #4 (Power
Cable) to supply power to both Z Units and you’ll be ready to brew.
Assemble the Top Z Unit
4
5
4 SCREWS IN
CORNERS
Pro Tip:
Insert & lightly
hand-tighten all
screws before using
T20 driver to fully
tighten screws.
REPLACE
RUBBER MAT