Pioneer AVIC-Z1000D33-CHU User manual

Installation guide for :
- AVIC-Z1000D33-CHU
Installation kit - metal brackets and plastic facia
with rotary command keys
Interface
Depending on the kit, the interface may look different
Original dashboard setup
Remove the storage pockets
Cut the support bars in line with the dash Dashboard after cutting
Locate the two support bars left and right
in the dashboard
Pioneer installation manual - Fiat Ducato 7 - v3.01
Fiat Ducato model year ’14 - Open dash only





Start with the right side bracket Put it in the radio cavity
Once inside, turn the bottom part downwards Make sure the bottom mounting point in over
the original mounting point
Pull the top mounting point underneath the
original one to the front
Next take the left side bracket
Pioneer installation manual - Fiat Ducato 7 - v3.01







Also put it sideways Once inside, turn it making sure the mounting
points are in front of the original ones
Align the fixation points of both brackets Start with the front lower one
Continue with the lower rear fixation End with the top one






Pioneer installation manual - Fiat Ducato 7 - v3.01

Secure the cage on the bottom mounting
points using the original screws
Secure the cage on the upper mounting
points using the original screws
Make sure to pull the connection cable for the
rotary commander out underneath the cage
Attach the side brackets to the Pioneer unit
Left side
Attach the side brackets to the face panel
Left side
Attach the side brackets to the Pioneer unit
Right side






Pioneer installation manual - Fiat Ducato 7 - v3.01

Attach the side brackets to the face panel
Right side
Final look of the mounting cage in
the dashboard
Remove two screws at the bottom of
the tacho visor
Remove the tacho visor
It is still secured with clips
Remove two screws from the tachometer Remove the connector by sliding the red tab
away from the cables
Pioneer installation manual - Fiat Ducato 7 - v3.01







Cut the cable tie and slide the cables out
towards the bottom
Remove the blue and white cable from the
connector by pressing with a small screwdriver
Insert the two pins in the supplied plug
Press the cover to lock the pins
Install the blue and white cable from the
interface in the tacho connector (pos. 4 & 5)
Slide the cables back into the main housing
and secure with new cable tie or electric tape
Connect back to the tacho and to the interface
Pioneer installation manual - Fiat Ducato 7 - v3.01








Install and connect the head up display
onto the new tacho visor
Install the visor with head up display and
secure with the orignal screws
Pioneer installation manual - Fiat Ducato 7 - v3.01


Push until the spring mechanism clicks
! Visual representation only
Airvents do not need to be removed !
Connect the rotary connector plug and
slide the unit in the dashboard
Once all connections are made, the unit
can be pushed in the dashboard
Finished installation



