Pioneer CA-HM-UNI-EVO.001 User manual

Installation manual CA-HM-UNI-EVO.001 | Version 2.0
EN - Installation Manual
Open locking mechanism
Metal cage Unit support
Screen support
Unit cover
Small hardware
Screen connector cover
Screen neck
Screen cover
Left& right support brackets installed
Mount side support bracket with the hardware
supplied (included with the installation kit)
Mount unit support to the side brackets
using the supplied hexagonal bolds
(included with the installation kit)
1 2
4
3
CA-HM-UNI-EVO.001
INSTALLATION KIT FOR SPH-EVO62DAB

Installation manual CA-HM-UNI-EVO.001 | Version 2.0
Completed installation of unit
with unit support
Slide the complete mechanism into the metal cage
Mount screen support to the screen using
the two center screws on each side
(included with SPH-EVO62DAB)
Install sliding mecha using the shown hardware
(included with the installation kit)
Lock the unit support into the metal cage by opening the two
metal tabs and tighten the indicated screws (on both sides)
Mount screen cover onto the screen support
using the remaining four screws as indicated
(included with SPH-EVO62DAB)
5 6
8
10
7
9

Installation manual CA-HM-UNI-EVO.001 | Version 2.0
Pull screen cable over the unit into the opening
and install the unit cover
Completely inserted screen neck
Slide the screen neck into the unit cover,
pay attention to the positioning of the tabs
Slide the screen support into the unit support
12 13
1514
Mount screw covers, paying attention to the marked numbers and locations
11
1 2
4 3

Installation manual CA-HM-UNI-EVO.001 | Version 2.0
Pull the screen neck towards the screen holder
until it ‘clicks’ into place
Slide the connector cover in the back of the screen
and fix the screw (included with SPH-EVO62DAB)
18 19
Final product image
Choose the desired distance for your screen and tighten
the two screws on top (included with the installation kit)
Insert the connector into the screen
1716